Comco AccuFlo AF10-CE Посібник - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник для Промислове обладнання Comco AccuFlo AF10-CE. Comco AccuFlo AF10-CE 14 сторінок.

A10‐CE Control Connector

Blast Control: Pin 1 provides 115VAC power from the AccuFlo. The host must provide a switch to

put this voltage back in to Pin 2, which will cause the blaster to blast. When Pin 2 is left floating,

the blaster will not blast. 200mA of current is typical.

PE: Pin 4 provides an optional bonding path to Primary Earth through the AccuFlo. If the host is

otherwise bonded to PE, do not use this pin.

Regulator Control: The regulator must be powered by 24vdc through Pin 7 and ground through Pin

6. The regulator requires 60mA of current. The blast pressure is set by providing a 0‐10vdc signal

at Pin 8, which corresponds to a pressure of 0‐148psi. The internal resistance of the regulator's

input is 100ohms minimum.

AF10‐CE Cables and Controllers

Cabling and control depends on how the user desires to control the AF10‐CE. Use the above table

to determine which cable to use. If the AF10‐CE is paired with an AutoFill unit, refer to the AutoFill

manual for additional wiring information.

Tech Support: 1‐818‐841‐5500