Follett VU155N Series Посібник з монтажу, експлуатації та обслуговування - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з монтажу, експлуатації та обслуговування для Диспенсер для води Follett VU155N Series. Follett VU155N Series 20 сторінок. Ice and water dispensers
Також для Follett VU155N Series: Технічні характеристики (2 сторінок), Посібник з монтажу, експлуатації та обслуговування (20 сторінок)
Service
Dispense chute cover removal
1. Remove top cover.
2. Push chute cover up vertically to slip off
holding tab.
3. After clearing tab, pull chute cover forward
to remove.
Dispense mechanism assembly removal
1. Remove top cover.
2. Remove chute cover (see above).
3. Remove auger motor assembly (see above).
4. Remove quick release pins from the ice chutes and
gates, then unplug wires from solenoids.
5. Lift dispense mechanism up and off auger tube.
Auger and auger tube removal
1. Remove auger motor and dispense mechanism
assembly (see above).
2. Pull auger upward to clear auger tube.
3. Lift auger tube upward to clear dispenser top.
4. Slide tube and bearing plate through auger
tube gasket.
Dispense wheel removal
1. Remove drain pan assembly and bin access cover.
2. Remove center thumbnut and threaded rod on
dispense wheel assembly and lift wheel out front
access opening.
Auger motor assembly removal
1. Remove top cover.
2. Remove one thumbnut on rear of motor bracket.
3. Lift motor bracket up and unplug electric
quick disconnects.
4. Remove motor assembly.
Dispense wheel motor removal
1. Remove drain pan, bin access cover and
dispense wheel.
2. Remove stainless steel baffle plate under
dispense wheel.
3. Remove two screws holding wheel motor
bracket on bin.
4. Lift plate and motor up.
5. Unplug electric quick disconnects from motor.
6. Lift motor and mounting plate out front
access opening.
Fig. 1
(Fig. 3)
Fig. 2
(Fig. 3)
10
Front View
right-hand unit
drain pan
assembly
Dispense assembly, Top View
right-hand unit
quick
release
pin
top cover
chute
cover
dispense
chute
solenoid
gate
ice chute