Follett EREF Series Посібник з монтажу, експлуатації та обслуговування - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник з монтажу, експлуатації та обслуговування для Холодильник Follett EREF Series. Follett EREF Series 20 сторінок. Undercounter refrigerator

Follett EREF Series Посібник з монтажу, експлуатації та обслуговування

The Controller Replacement

1. Shut down unit by moving rocker switch on the lower front panel to the OFF position and removing power
cord from receptacle.
2. Remove 6 screws from front panel and slide panel forward to access back of controller.
3. Disconnect front panel wiring harness at the 9-pin connector.
4. Push in on center of the side brackets (on controller) to release and slide brackets back and off controller.
5. Push controller and wires out through front of front panel.
6. Disconnect the wiring from the controller.
7. Using the wiring diagram attached to front panel as a guide, reconnect wires to the new controller.
8. After connecting the wires, insert replacement controller back through front of panel and slide brackets
onto sides of controller and push against back of front panel.
9. Reconnect 9-pin connector of wiring harness.
10. Keeping wiring clear of condenser, replace front panel.
11. Restore power and test operation.
12. Reprogram replacement controller if necessary.

Wiring Diagram

Refrigeration System

The EREF Series refrigeration system is designed to give many years of trouble-free service. Except for routine cleaning
of the air-cooled condenser and related parts, the refrigeration system requires no service or maintenance. The system
uses a capillary tube and is critically charged. Access fittings are provided for ease of service. However, the connection
of refrigeration service hoses to the fittings will almost invariably result in a significant change in the system charge.
This change can adversely affect the performance of your refrigerator. Therefore, Follett recommends that if hoses are
ever connected to the refrigeration system for service, the refrigerant should be recovered, the system evacuated, and
recharged by weighing in the correct refrigerant charge.
Note: Do not charge the system by pressures.
12
EREF Refrigerator