AMPTech S Посібник з монтажу - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільні аксесуари AMPTech S. AMPTech S 18 сторінок. Softclose automatic

● 6 T20 screws are removed so that the plastic inner lining can be

dismantled

The speaker is also dismantled by removing 4 screws

● The next step is to remove 2 T30 screws from the lock unit so that the

lock can be carefully lifted out through the opening behind the

windowpane guide. The plug connected to the lock unit must be

disconnected

ATTENTION:The window must be fully raised during this step.

● The Bowden cable must be removed from the old lock and connected

to the new lock unit. To do this, loosen the plastic barbs with a slotted

wrench.

The lock unit with yellow Styrofoam is used for the right side of the

vehicle (analogously, unit with blue Styrofoam is for the left side of the

vehicle).

First, the Bowden cable must be attached to this lock.

ATTENTION: The end piece of the Bowden cable must be hooked

behind the lug provided for this purpose in the new lock.

● Attach the plug for the lock unit to the new lock unit

● The new lock unit can now be inserted into the door behind the

windowpane guide. The two T30 screws previously loosened on the

old lock are used to secure the new lock unit.

● In the next step, the soft close motor is glued to the door body facing

outwards with the butyl already attached to the motor. Make sure

that the pull cable of the motor is not kinked and leads straight from

the motor to the lock unit.

before

lifting

out.