CardAccess ZGB20 Посібник із швидкого запуску та встановлення - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник із швидкого запуску та встановлення для Бездротова точка доступу CardAccess ZGB20. CardAccess ZGB20 12 сторінок. Security sensor bridge v2
Друкувати сторінку5. Select the generic proxy of your choice and at it to your project. Go to the Connections tab, and under
Control/AV, bind the output for the sensor to this proxy. DO NOT change the input bindings.
Diagnostic Indications
The Security Sensor Bridge has two LEDs which indicate its current operational state. During normal operation, these
LEDs will help to determine if the bridge is functioning properly. The tables below provide a brief summary of these LEDs:
BUS LED (top):
GREEN (solid)
RED (solid)
RED (short winks OFF)
RF LED (bottom):
GREEN (short winks ON)
_________________________________________________________________________________________________________________________
Card Access Security Sensor Bridge V2
Quick Start & Installation Guide
Bridge is connected to Control4 automation system and operating
properly (ZigBee connection established, driver properly identified)
ZigBee PRO: Bridge is not connected to the ZigBee mesh.
ZigBee PRO: Bridge is connected to the ZigBee mesh but is not
communicating with the ZGB20 driver. Ensure bridge has been
identified into the system.
EmberNet: Bridge is not communicating with the ZGB20 driver.
Ensure bridge has been identified into the system.
Wireless sensor activity
Page 5 of 12
Card Access, Inc.