Electrolux # Посібник з використання та догляду - Сторінка 6

Safety

• Wear proper apparel—Loose-fitting or hanging garments should never be worn

while using the appliance. Do not let clothing or other flammable materials contact

hot surfaces.

• Do not use water or flour on grease fires—Smother the fire with a pan lid, or use

baking soda, a dry chemical or foam-type extinguisher.

• When heating fat or grease, watch it closely. Fat or grease may catch fire if allowed

to become too hot.

WARNING

In case of fire or gas leak, be sure to turn off the main gas shutoff valve.

• Use only dry potholders—Moist or damp potholders on hot surfaces may result in

burns from steam. Do not let potholders touch hot heating elements. Do not use a

towel or other bulky cloth instead of a potholder.

• Do not heat unopened food containers—Buildup of pressure may cause

container to burst and result in injury.

• Remove the oven door from any unused range if it is to be stored or discarded.

IMPORTANT—Do not attempt to operate the oven during a power failure. If the

power fails, always turn the oven off. If the oven is not turned off and the power

resumes, the oven may begin to operate again. Food left unattended could catch fire or

spoil.

WARNING

Use proper flame size—Adjust flame size so it does not extend beyond the edge of the utensil. The

use of undersized utensils will expose a portion of the burner flame to direct contact and may result in

ignition of clothing. Proper relation of utensil to flame will also improve cooking efficiency.

WARNING

Do not use stove top grills on the burner grates of sealed gas burners. If you use a stove top grill on a

sealed gas burner, it will cause incomplete combustion and can result in exposure to carbon monoxide

levels above allowable current standards. This can be hazardous to your health.

CAUTION

UTION

Electronic controllers can be damaged by cold temperatures. When you use your appliance for the

first time, or if it has not been used for a long period of time, make sure that it has been exposed to a

temperature above 0°C/32°F for at least 3 hours before connecting it to the power supply.