Electrolux # Інструкція з монтажу Посібник з монтажу - Сторінка 7

30" GAS RANGE INSTALLATION INSTRUCTIONS

4. Adjust the "LOW" Setting of Regular Burner (see

figure 8) on the Surface Burner Valves (Figure 9):

a. Push in and turn control to LITE until burner ignites.

b. Quickly turn knob to LOWEST POSITION.

c. If burner goes out, reset control to OFF.

d. Remove the surface burner control knob and

decorative ring.

e. Insert a thin-bladed screwdriver into the hollow valve

stem and engage the slotted screw inside. Flame

size can be increased or decreased by turning the

screw. Turn counterclockwise to increase flame size.

Turn clockwise to decrease flame size. Adjust flame

until you can quickly turn knob from LITE to LOWEST

POSITION without extinguishing the flame. Flame

should be as small as possible without going out.

Note: Air mixture adjustment is not required on surface

burners.

Figure 9

5. Adjust the "LOW" Setting of the Dual Burner

(see Figure 8) on the Surface Burner Valve (Figure

10):

Note: On the dual valve the low setting of each portion

(rear portion of bridge burner and the center portion of

bridge burner) should be adjusted individually.

a. Push in and turn control to LITE until the rear portion

of the bridge burner ignites only.

b. Quickly turn knob to LOWEST POSITION.

c. If burner goes out, reset control to OFF.

d. Remove the surface burner control knob.

e. The inner portion of the dual burner flame size can be

increased or decreased by turning screw A (see Figure

10). Use screw B to adjust the flame size of the outer

portion of the dual burner. Turn counterclockwise

the screw to increase flame size. Turn clockwise the

screw to decrease flame size. Adjust flame until you

can quickly turn knob from LITE to LOWEST POSITION

without extinguishing the flame. Flame should be as

small as possible without going out.

Note: Air mixture adjustment is not required on surface

burners.

Figure 10