Electrolux 95G Інструкція з експлуатації - Сторінка 16
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Холодильник Electrolux 95G. Electrolux 95G 20 сторінок. Gas and mixed fuel cookers
Також для Electrolux 95G: Інструкція з експлуатації (20 сторінок), Інструкція з експлуатації (24 сторінок), Інструкція з експлуатації (20 сторінок)
Друкувати сторінку
Adaptation to different kinds of gas
To adapt the appliance to a different kind of gas from the
one the appliance has been set for, follow the instructions
below in their order.
Upon completion replace the rating plate with the relevant
one (supplied with the appliance) for the new type of gas
supply.
Replacement of rubber pipe
holder
Liquid gas preset range:
to set the range ready for natural gas, use rubber pipe
holder «A». (Fig. 21)
Natural gas preset range:
To set the range ready for liquid gas, use the rubber pipe
holder «B».
Always insert the gasket «C» between the feeding pipe
•
and the rubber pipe holder. (Fig. 21)
Replacement of nozzles and
adjustment
Nozzle replacement:
- Remove the pan supports.
- Extract the caps and the crowns of the burners.
- Using a socket spanner 7 unscrew and remove (Fig.
22) the nozzles replacing them with the ones required
for the kind of gas in use (see tables pag. 18).
• Town gas (Hong Kong)
a) Auxiliary burner and semi-rapid burners: after fitting
the nozzles (Fig. 23 - lett. "B"), screw the provided grid
filter "A" (Ø 10) on them;
b) Rapid and Ultra-rapid: screw the provided grid filter
assembly "C" (Ø 16) on it.
Reassemble the parts following the same procedure
backwards.
These burners do not need any primary air regulation.
Adjustment of minimum level of
plate burners
To adjust the minimum level:
1)
turn the knob to the position of minimum flame;
2)
remove the knob (Fig. 24);
3a) in case of conversion from natural gas to liquid
gas, tightly screw the by-pass pin of the cocks;
3b) when converting from liquid gas to natural gas
unscrew about one-fourth turn by-pass pin, until a
regular small flame is reached;
3c) in case of conversion from natural gas to town
gas, unscrew about three-fourth turn by-pass pin,
until a regular small flame is reached;
3d) when converting from liquid gas to town gas
unscrew about one turn by-pass pin, until a regular
small flame is reached.
Reassemble the parts following the same procedure
backards.
Check that, turning quickly the knob from the maximum
position to the minimum one, the flame does not go out.
1 6
Fig. 21
Fig. 22
Fig. 23
Fig. 24
by-pass screw
Fig. 25