Electrolux AF Series Посібник користувача - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник Electrolux AF Series. Electrolux AF Series 18 сторінок. Refrigeration
Також для Electrolux AF Series: Посібник користувача (18 сторінок)
Друкувати сторінку
Bottle twist holder operation (where fitted)
The bottle twist holder is used to prevent bottles from falling
over. The bottle twist holder consists of two parts, a sliding
front, and a rotating retainer ring.
The bottle twist holder can be used in two positions:
•
Horizontal
When the bottle twist holder ring is horizontal, any item
that fits within the ring can simply be placed inside it.
•
Vertical
When the bottle twist holder ring is vertical, it is possible
to simply slide the bottle twist holder along the bottle
retainer bar until it is pushed up against a bottle.
Note:
The bottle should be constrained on the other side by either
the end of the bin or other adjacent bottles.
Freezer baskets (where fitted)
Freezer baskets and a freezer shelf are fitted to bottom
mount (BM) freezers and single door all freezers (AF).
Wire baskets are used to provide easy visibility of the
contents. Both the baskets and the shelf pull out for easy
access and have a stop to prevent the basket and shelf
being pulled out too far.
To remove the basket or shelf, pull it out until it hits the stop
then lift the front to unhook the stop while continuing to pull
forward.
electrolux refrigeration care and maintenance 9
Care and maintenance
Changing the light bulb
•
Refrigerator light
.
Switch off the power at the power point and
remove the refrigerator's power cord from the
power point.
2.
Remove shelves.
3.
Carefully unclip the light cover. You do this by
pulling the upper part of the cover towards the front
of the cabinet.
4.
Unscrew the light bulb and replace it with a bulb
that is the same as the original.
5.
Replace the light cover by hooking the light cover
lugs into the bottom of the housing and pressing
the upper part of the cover until it clips in.
6.
Replace shelves.
7.
Wait 5 minutes to ensure pressures in the
refrigeration system are equalized. Then reconnect
and turn the refrigerator on at the power point.
•
Freezer light (where fitted)
.
Switch off the power at the power point and
remove the refrigerator's power cord from the
power point.
2.
Carefully unclip the light cover. You do this by
pulling the light cover tab at the rear towards the
front of the cabinet.
Top freezer model
(electronic models only)
3.
Unscrew the light bulb and replace it with a bulb
that is the same as the original.
4.
Replace the light cover by hooking the light cover
lugs into the front of the housing and pressing the
rear of the cover up until it clips in.
5.
Wait 5 minutes to ensure pressures in the
refrigeration system are equalized. Then reconnect
and turn the refrigerator on at the power point.
Single door all freezer model