Bosch Ascenta SHE5AM02UC Інструкція з ремонту - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з ремонту для Посудомийна машина Bosch Ascenta SHE5AM02UC. Bosch Ascenta SHE5AM02UC 27 сторінок. Quick reference instructions
Також для Bosch Ascenta SHE5AM02UC: Інструкція з монтажу Посібник з монтажу (21 сторінок), Енергетичний посібник (2 сторінок), Початок роботи (2 сторінок), Інструкція з ремонту (50 сторінок)

COMPONENTS

4.1

4.1.1

Tank, base and sump assembly

The tank, base and sump are welded together and aren't

available as a service part. If plastic cable holders, part holders

and screw holes are damaged or stripped, the entire dishwasher

must be replaced.

4.1.2

Rear leveling foot

The rear leveling foot can't be adjusted from the front – the rear

foot is the same as front feet and is adjusted the same way. The

base has provision for two rear feet in the rear corners, but the

center foot factory mounting should be used.

Factory feet positions have provisions for set screws (in

installation parts bag).

Outside rear positions don't have set

screw positions and shouldn't be used.

702_58300000130262_ara_en_b

Center rear

adjusting foot

Right rear

adjusting foot

4.2

There's no flow-through heater, flow switch or Hi-Limit cutout –

the circulation pump has a flow-through heated cylinder. The 120

VAC, 1200W heater cylinder provides more heating surface area

and heats water slightly more quickly than traditional flow-through

heating elements (~ 2ºF/minute). The circulation pump (portion)

has a 3-pole BLDC motor controlled by the power (control)

module. The dishwasher won't run if the heat pump is

disconnected or disabled.

Pump suspension strap

Seal ring

The heat pump is accessible from the bottom or the back, but is

best accessed from the bottom.

Center rear foot set screw hole

Heating element

Page 9 of 27