DragonEye SPEED LIDAR Посібник оператора - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник оператора для Радар-детектор DragonEye SPEED LIDAR. DragonEye SPEED LIDAR 10 сторінок.

panel will also display a test pattern of alphanumeric characters

along with icons (note: not all icons may be active during use on your

software version). If all displays are illuminated and legible the

operator must press the

commence a series of internal tests and displays on the rear panel:

1. ChkSum: verifies no corruption of firmware

2. Firmware Version is displayed

3. DataFlash: verifies no corruption of specific unit settings in

flash memory (e.g. unit of measure, menu items, etc.)

4. Serial Number is displayed

5. Battery Voltage is displayed

6. Unit Temperature is displayed

Alignment Test

The operator will be prompted to complete a horizontal and vertical

alignment test of the HUD aiming reticle by selecting a target with

straight boundaries such as a utility pole or road sign at a distance of

30 metres or greater. While holding the trigger in, slowly pan the aim

point on and off the target edge, verifying the range reading in the

HUD changes as the reticle passes onto the target. The preceding

verifies horizontal alignment. Rotate the unit 90° onto its side while

continuing to look through the HUD and repeat the above test to

verify vertical alignment. This will allow the operator to confirm that

the infrared energy is contained within the aiming reticule and the

Lidar will confirm the range selected to perform this test. The

operator will again be prompted to press the

Canadian DragonEye Speed LIDAR

DragonEye Technology, LLC | Doc. 30508 Rev 05

button to verify. The unit will

Operator Manual

button.