Drainvac ProXtrak DV2P552 Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Водяний насос Drainvac ProXtrak DV2P552. Drainvac ProXtrak DV2P552 12 сторінок. Liquid extractor proxtrak series

Друкувати сторінку

GROUNDING INSTRUCTIONS

These units must be grounded. If it should malfunction or breakdown, grounding
provides a path of least resistance for electric current to reduce the risk of electric
shock. This appliance is equipped with a cord having an equipment-grounding
conductor and grounding plug. The plug must be inserted into an appropriate
outlet that is properly installed and grounded in accordance with all local codes
and ordinances.
WARNING - Improper connection of the equipment-grounding conductor can result in
a risk of electric shock. Check with a qualified electrician or service person if you are in
doubt as to whether the outlet is properly grounded.
DO NOT MODIFY THE PLUG PROVIDED WITH THE UNITS.
IF IT DOES NOT FIT THE OUTLET, HAVE A PROPER OUTLET INSTALLED
BY A QUALIFIED ELECTRICIAN.
These units are for use on a nominal 120V or a 230V circuit and have a grounding
attachment plug that looks like the one illustrated below. Make sure that the electrical
cord is connected to an outlet having the same configuration as the plug.
NO ADAPTOR SHOULD BE USED WITH THIS APPLIANCE.
Grounded
Grounded pin
*Illustration of a north-americain electrical outlet
14
Outlet

MAINTENANCE PROCEDURES

Each system requires a minimum maintenance, without any exception.
MOTOR BRUSHES
Beyond the occasional external cleaning, we recommend that you inspect your motor
brushes after 500 hours of use to check how worn they are and have them replaced if
necessary. When the time comes, contact your retailer or distributor for this maintenance
procedure. Take note that the motor brushes are not included in the warranty.
VISUAL INSPECTION
Your Automatik system is very user-friendly and we recommend a visual inspection
through the porthole once a year or when needed. If you wish to clean the inside of
the unit, refer to the following section "Regular Maintenance".
REGULAR MAINTENANCE
The only maintenance required is cleaning the inside of
the unit.
To proceed, you just have to remove the porthole glass
as illustrated, by pivoting it in an anti-clockwise motion
using the handles.
Use a scouring sponge to especially clean the protective
screen, the two electrodes and, if needed, the tank.
A blocked protective screen could reduce the unit's
performance and dirty electrodes could not adequately
send a signal to the unit to pass on to the wastewater
evacuation cycle.
Electrode
At the same time, it is recommended to visually
Water inlet
inspect the water inlet pipe and the rubber hand to
Protective screen
1
2
make sure that no foreign object is obstructing
the water flow.
15