AirStage ARXD18GALH Посібник з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з монтажу для Кондиціонер AirStage ARXD18GALH. AirStage ARXD18GALH 20 сторінок. Indoor unit (duct type)

AirStage ARXD18GALH Посібник з монтажу
Tool name
Pressure is huge and cannot be measured with a
conventional (R22) gauge. To prevent erroneous mixing
of other refrigerants, the diameter of each port has been
Gauge manifold
changed.
It is recommended to use a gauge manifold with a high
pressure display range –0.1 to 5.3 MPa and a low pressure
display range –0.1 to 3.8 MPa.
To increase pressure resistance, the hose material and base
Charging hose
size were changed.
A conventional (R22) vacuum pump can be used by installing
a vacuum pump adapter.
Vacuum pump
Be sure that the pump oil does not backflow into the system.
Use one capable for vacuum suction of –100.7 kPa (5 Torr,
–755 mmHg).
Gas leakage detector
Special gas leakage detector for HFC refrigerant R410A.

2.3. Accessories

For installation purposes, be sure to use the parts supplied by the manufacturer or
other prescribed parts.
The use of non-prescribed parts can cause serious accidents such as the unit to fall,
water leakage, electric shock, or fi re.
The following installation parts are furnished. Use them as required.
Keep the Installation Manual in a safe place and do not discard any other accessories
until the installation work has been completed.
Do not discard any accessories needed for installation until the installation work has
been completed.
Name and Shape
Operating Manual
Installation Manual
Installation template
Washer
Coupler heat insulation (Large)
Coupler heat insulation (Small)
Contents of change
WARNING
Q'ty
Application
1
(This book)
1
For positioning the indoor unit
1
For installing indoor unit
8
For indoor side pipe joint (Large pipe)
1
For indoor side pipe joint (Small pipe)
1
Name and Shape
Cable tie (Medium)
Cable tie (Large)
Filter (Small)
(AR04/07/
09/12/14/24)
Filter (Big)
2 (AR18)
1 (AR24)
Drain hose
Hose band
Drain hose insulation B

2.4. Optional parts

Description
Model No.
IR receiver unit
UTB-*WC
Remote sensor
UTY-XSZX
External output wire
9379529013
External input wire D
9368779016
External input wire F
9368779023
External input wire B
9368778002
External input wire E
9368778019
Auto louver grille
UTD-G*S*-W
Q'ty
Application
For transmission and remote controller
cable binding
2
For fixing the coupler heat insulation.
4
2
For installing drain pipe VP25
(O.D.32, I.D.25)
1
For installing drain hose
1
Insulates the drain hose
1
Application
For the wireless remote
controller.
Room temperature sensor
For output port
For control input port
(Apply voltage terminal)
For control input port
(Dry contact terminal)
For forced thermostat off port
(Apply voltage terminal)
For forced thermostat off
port (Dry contact terminal)
For Auto louver grille
En-2