Dramm Autofog MLVH-10A Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Фарборозпилювач Dramm Autofog MLVH-10A. Dramm Autofog MLVH-10A 20 сторінок.
Друкувати сторінку
The key to successful results with the MLVH-10A is
keeping the machine clean. There are only a few
steps involved, so it will be very easy. Be sure to
clean the machine after every use.
1. Using warm water and a soft cloth wash:
A. The Solution tank
B. The Solution tank cover
C. The Agitator blades
D. The Suction tube
E. Spray clear water through nozzle
F. Wipe off the machine
Nozzle
2. Remove the nozzle from the MLVH-10A by
unscrewing the securing nut. Remove the nozzle
cap and wipe off any chemical residue. Always
handle the nozzle and cap with care, especially the
nozzle tip (see diagram below). Inspect the nozzle
cap O-ring for damage or wear.
NOTE:
This procedure is necessary after every application
of wettable powder solutions. Be sure to remove
the nozzle cap and clean the nozzle.
13
Dramm Autofog MLVH-10A Manual
Cleaning & Maintenance
Nozzle Cap
O-Ring
Nozzle Tip
Air Filter Housing
Air Filter
Compressor Air Filter
REPLACE FILTER ONCE A YEAR OR AFTER
500 HOURS OF USE.
3. After every 25 hours of use, be sure to clean the air
filter (Located under the compressor housing, on
top of the compressor). Brush any excess debris off
the filter and then rinse with warm water. Use a
mild detergent if necessary. ALWAYS let the filter
air dry completely before reinstalling.
NOTE:
The air filter will contain particles of the chemicals
you have been applying. When cleaning the filter
follow all EPA Guidelines for the handling and
disposal of chemicals.
4. Store the MLVH-10A where it is away from
excessive moisture, children and unauthorized
personnel. If you are storing the MLVH-10A for a
long period of time, cover the equipment with a
plastic sheet.
A video showing the
cleaning procedure for
the MLVH is available on
our website.