Dramm HYDRAG-ST100 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Фарборозпилювач Dramm HYDRAG-ST100. Dramm HYDRAG-ST100 20 сторінок.

1. Fill the sprayer tank at least 3/4 full with water ONLY.

2. Dilute (mixing to dissolve) chemicals with water in a 5 gallon bucket. Never put

concentrated chemical formulations directly into the tank without diluting with water.

3. Start sprayer with pressure regulator in START (priming) position to beginagitation process

prior to adding chemical to sprayer tank.

4. Pour chemical and water mixture (slurry) into the sprayer tank, filled 3/4 full of water, after

agitation has begun.

5. Fill remainder of sprayer tank with water.

1. Periodically check the pump oil level

If it is below the indication, add oil though

the filler (H). Oil should be changed after

the first 50 hours of operation. Use 10 w 30

oil, preferrably non-detergent.

2. Periodically lubricate the grease fittings

on the wheels

bearing grease to extend the wheel

bearing life.

3. Replace the spray gun tip every season.

As the hole in the tip gets larger the spray

pressure drops and degrades the quality

of the spray. (K)

4. Thoroughly clean the in?line filter, tank

and machine on a weekly basis.

5. To drain tank, rotate the drain valve (L.)

90° allowing flow from the drain hose. To

completely drain tank, remove the lower

housing of the in-line filter (M). *After

draining, clean the filter, replace the

housing and close the drain valve (L) to

ensure that upon refilling the tank? the

chemical will not drain out of the unit.

Hydra SprayTrax Manual

Chemical Mixing Procedure

Maintenance & Cleaning

with a good grade of

(G)