Bosch AXXUS WFL 2050 Інструкція з експлуатації та монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та монтажу для Пральна машина Bosch AXXUS WFL 2050. Bosch AXXUS WFL 2050 36 сторінок. Bosch appliances washer user manual
Також для Bosch AXXUS WFL 2050: Інструкція з експлуатації та встановлення (37 сторінок)
Друкувати сторінку
About Your Washin
achine
The washing machine offers the following standard
features:
-
Horizontal-Axis,
Tumble Action Wash System,
without agitator
-
Stainless Steel Inner Wash Drum
-
Exceptionally
Low Energy and Water
Consumption
-
Internal Heating Element, for Power temp boost,
up to 160 °F (71 °C)
-
High Spin Speeds, up to 1,000 rpm, remove
more water from fabrics to reduce drying time
and energy.
-
4 Fabric and 5 Temperature
Settings.
-
3 special cycles
-
3 additional functions
Before Using For the
First Time
The washing machine must have been installed
and connected
properly (refer to page 26).
Before beginning to use your washing machine for
the first time:
Check to make sure that the voltage on which
the washing machine is to operate is the same
as shown on the rating plate.
Check to make sure that the water valves to the
washing machine are open.
Using For the
Time
First
Your appliance was tested before leaving the
factory. To remove any water left over from testing
procedures,
the first washing cycle should be
carried out without laundry in the machine.
Do not load any laundry.
Turn on the water tap.
Pull out the detergent dispenser
up to the end
stop.
Pour approx.
1 litre / 1 3A pt of water into
chamber II of the detergent
dispenser.
Half fill the measuring beaker with detergent
and pour into chamber II. Do not use any
special detergents
for delicates or woollens
(excessive foam).
Close the detergent dispenser.
Set the program selector to Power temp
boost.
The ready control light is flashing.
Press the Start button.
The wash control light comes on, and the
program
starts.
[] door locked
illuminates while the program is
running.
The wash control light changes during the
program to rinse/spin.
When the finished
flashes:
Set the program selector to Off.