Draper Curved Onyx Інструкція зі збирання/монтажу

Переглянути онлайн або завантажити pdf Інструкція зі збирання/монтажу для Проекційний екран Draper Curved Onyx. Draper Curved Onyx 3 сторінки. Permanently tensioned projection screen

Друкувати сторінку

Curved Onyx Permanently Tensioned Projection Screen by Draper

1 Read instructions through completely before proceeding.

2 Follow instructions carefully. Installation contrary to instructions

invalidates warranty.

3 Screen should be accessible for complete removal should fabric

become damaged or should other service be required.

4 Screen should be installed level (using a carpenter's level).

5 Nothing should be fastened to screen frame or viewing surface.

6 Make sure you have received all parts (see parts list below and

exploded diagram on page 2).

7 Tools Required: Medium (#2) Phillips screwdriver (6" or greater shaft

length suggested). Optional tools: Flat blade screwdriver or small

putty knife.

8 Installer is responsible for providing appropriate hardware for mounting.

9 When lifting assembled screen, do not lift at only one corner; lift at

both corners. Lifting by one corner could result in damage to the

screen frame, especially on large screens.

10 The ideal temperature range for assembling folding screens to prevent

damaging the surface is 68°-78° F (20°-26° C). Assembling below

recommended temperatures may damage surface and void warranty.

NOTE: Screen has been thoroughly inspected and tested at factory and

found to be operating properly prior to shipment.

Curved Onyx—Hardware and Parts List

Frame Extrusions - 4

#10-24 fasteners - 8

Surface Retention

Extrusions- varies

Brackets -

See last page of

instructions

Frame Preparation

1 Clean area and place frame assembly pieces face down. Insert plastic

corner pieces into ends of aluminum frame extrusions as indicated in

Figures 1 through 4. Secure each corner to each frame extrusion by

threading one #10-24 fastener through hole in plastic corner and into

rounded slot in aluminum frame extrusion.

Caution: Do not over-tighten fasteners—over-tightening could cause

damage to the frame corners.

Patented by Draper, Inc., U.S. Patent Nos. 6,785,047; 7,113,332; and 7,369,310.

Form CurvedOnyx_Inst13 Printed in U.S.A.

Assembly/Mounting Instructions

Caution

Frame Corners - 4

Right-C173.042

Left-C173.043

Four-C098.018

Plastic Tubing - 4

Viewing Surface - 1

Figure 1

2 Secure corner pieces to aluminum frame extrusions with four (4) remaining

fasteners. Check to verify that all four (4) plastic corners are secure to

aluminum frame extrusion lengths and all eight (8) fasteners are tight (see

Fig. 5).

Caution: Do not over-tighten fasteners—over-tightening could cause

damage to the frame corners.

Caution: When lifting assembled screen, do not lift at only one corner; lift

at both corners. Lifting by one corner could result in damage to the screen

frame, especially on large screens.

If you encounter any difficulties installing or servicing your Onyx screen, call your

dealer or Draper, Inc., Spiceland, Indiana, (765) 987-7999 or fax (765) 987-7142.

Figure 2

Figure 3

Figure 4

Figure 5

(Continued on Page 2)