Draper FlexShade Інструкція з монтажу та експлуатації - Сторінка 10

Друкувати сторінку

FlexShade

Section 8 - Mounting Headbox and Side Channels in Recessed Pockets

(Alternate Hardware & Installation Method)

Please Note: 2" U Channel Adaptor option MUST be ordered for the channel to be included with unit —

it is not provided standard. Shade MUST be ordered 5/ 8 " narrower as well.

Please Note: Be sure to provide adequate clearance for removal of Roller Assembly during installation and maintenance.

Minimum depth of ceiling pocket is 7 9/ 1 6

NOTE:

Installer MUST provide a recessed pocket

at the top of the channel large enough

to allow for headbox installation and

accommodate hem bar and fascia install/

removal.

(Section ??)

E N

C A

Insert provided 'U' Channel into recessed cavity

in building structure. Drill mounting holes and

secure, using appropriate hardware

Please Note: Installer is responsible

for selecting mounting hardware

appropriate for site conditions.

Please Note: Specific Fastener

locations determined by installer.

Max. spacing between fasteners:

24"

(610mm)

C H A

W A L

Crank-Operated ZIP

Use a 3 mm Hex Wrench to remove Screws

from Side Channels and Side Channel Covers.

Please Note: Do NOT remove the

Bottom Caps from Side Channels.

(by others)

'C' Channel

Mounting Hardware

(by Others)

Speciﬁc Fasterner locations

determined by installer

' U '

N N E

W A L

or sufficient to conceal hem bar.

(159mm)

Please Note: Make note

of left & right covers,

to match up correctly

when re-attaching.

t o

T i n

C U

R E

U A

S Q

Foam

Padding

C054. 218

Remove Fabric Retainer

Strips from Side Channels.

Please Note: Make note of left & right

Fabric Retainer Strips, to match up

correctly when re-attaching.

Cut foam strips

into 1.5"

(provided)

squares and

(38mm)

attach them to the 'U'

Channel at all desired

mounting points of the

Side Channel.

' U '

C H A

N N E

W A L

page 10 of 16

U P

W A L