Draper 65027 Інструкція з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Draper 65027. Draper 65027 12 сторінок. 110v/230v router

Друкувати сторінку

1. Operation and Use

FITTING OR CHANGING THE CUTTER

Disconnect the machine from the power supply.

The machine is fitted with a

cutter ensure that the collet nut ✰✌ is loose. If not

push in the spindle locking plate ✱✌ until it

slides over the flat on the spindle and using a

27mm spanner loosen the nut. Insert the cutter

into the collet nut ✰✌ and with the spindle lock

engaged tighten the collet nut ✰✌ (Fig.5).

Before starting the machine ensure that the

spindle locking plate (H) is disengaged from the

spindle. To remove the cutter is the reverse

procedure.

SETTING THE DEPTH STOP

The router is fitted with a depth stop screw ✳✌

that can be adjusted to the required depth and

indicated on the scale ✴✌. The depth screw can

be adjusted by pushing button ✵✌ which will

allow the depth stop screw to move freely up and

down. For fine adjustment it can be screwed up

and down by using the knurled head ✶✌ (Fig.6).

DEEP CUTS

We recommend deep cuts are performed in three

stages using the depth turret ✷✌. The hex screws

can be set in the required positions by rotating

the turret (Fig.6).

When the required depth of cut is reached the

router can be locked into position by depth lock

lever ✹✌ (Fig.6a). (When using the router this

should be by your right hand).

The distance that the router will travel above the

work surface can be adjusted by screwing the

height stop knob ✻✌ (Fig.6).

OPERATION AND USE Cont'd.

" collet. To fit the

Fig.5

✱✌

Fig.6

✵✌

✶✌

✷✌

✹✌

Fig.6a

- 7 -

✰✌

✻✌

✴✌

✳✌

✼✌