Draper 83611 Посібник - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник для Електроінструмент Draper 83611. Draper 83611 20 сторінок. Biscuit jointer
Також для Draper 83611: Інструкція з експлуатації (20 сторінок)

Друкувати сторінку

BASIC BISCUIT JOINTER OPERATIONS

IMPORTANT: Make sure that the mains voltage

matches the voltage stated on the machines rating

plate.

Note: Remove the plug from the socket before

carrying out adjustment, servicing or maintenance.

8.1 ON/OFF LOCKING SWITCH – FIG. 1

To switch the biscuit jointer "ON" push the switch

button

towards the front of the machine.

Pushing it all the way forward will cause the button

to lock in place, for extended use.

To release the switch, press the back half of the

button in towards the machine body.

The switch will disengage and spring back to the

"OFF" position.

NOTE: Before plugging the Biscuit Jointer in,

ensure the switch is NOT locked in the "ON"

position.

8.2 BLADE DEPTH SELECTION – FIG. 2

The biscuit jointer has three depth settings which

are selectable using knob

arrow

The three standard settings correspond to the three

standard sizes of biscuits available:

0 = No.0 Biscuits.

10 = No.10 Biscuits.

20 = No.20 Biscuits.

NOTE: This biscuit jointer has a fourth setting (M).

This depth is the maximum depth capacity of the

machine and is only possible with a new blade fitted

and backing out the fine adjustment screw. This

setting will not be necessary for most biscuit jointing

operations and it is recommended that the operator

use only the 0, 10, 20 settings.

8.3 HEIGHT/ANGLE ADJUSTMENT –

FIG. 3

The position and angle of the biscuit can be set up

using the guide.

Loosen knob

and slide front rest

down to adjust the height. Lock with knob

The angle is also adjustable by loosening lever

Tilt the front rest

indicate the angle between 0-90º. When set, lock

knob

and indicated by

. Use the guide scale to

FIG.1

FIG.2

FIG.3

up or

- 13 -