Bosch WAK24270ZA/01 Посібник з експлуатації та інструкція з монтажу - Сторінка 27
Переглянути онлайн або завантажити pdf Посібник з експлуатації та інструкція з монтажу для Пральна машина Bosch WAK24270ZA/01. Bosch WAK24270ZA/01 38 сторінок.
Друкувати сторінку
Faults
Washing machine door
cannot be opened.
Programme does not
start.
Detergent solution is not
emptied.
Water not visible in the
drum.
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle started and
stopped several times.
The programme duration
is longer than usual.
The programme duration
changes during the wash
cycle.
Residual water in the
compartment i for care
products.
Odours in the washing
machine.
The N symbol flashes in
the display panel. Foam
may escape from the
detergent drawer.
Intense noise, vibrations
and "wandering" during
spinning.
Display panel/indicator
lamps do not function dur-
ing operation.
Cause/remedial action
Safety function active. Programme stopped?
■
– – – 0 (Rinse hold = without final spin) selected?
■
Can be opened by emergency release only?
■
Start/Reload or finished in time selected?
■
Washing machine door closed?
■
E Childproof lock activated? Deactivate.
■
– – – 0 (Rinse hold = without final spin) selected?
■
Clean detergent solution pump.
■
Clean the waste pipe and/or drainage hose.
■
Not a fault – water below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Easy Iron (depending on the model) selected?
■
Speed selected too low?
■
Not a fault – the unbalanced-load detection system is adjusting the imbalance.
Not a fault – the unbalanced-load detection system is adjusting the imbal-
■
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system active – adds an additional rinse
■
cycle.
Not a fault – the programme sequence is optimised for the particular washing
process. This may lead to changes in the programme duration in the display
panel.
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary.
■
Run Cottons 90 °C programme without laundry.
Use standard detergent.
Too much detergent used?
Mix one tablespoon of fabric softener with 1/2 litre water and pour into com-
partment II (not for outdoor fabrics, sportswear fabrics or those made with
down).
Reduce the detergent dosage for the next wash cycle.
Is the appliance levelled? Level the appliance.
■
Are the appliance feet fixed? Secure the appliance feet.
■
Transport locks removed? Remove the transport locks.
■
Power cut?
■
Circuit breakers tripped? Switch the circuit breakers back on or replace
■
them.
If the fault occurs repeatedly, call the after-sales service.
■
Faults and what to do about them.
en
27