AirStage ASUA14TLAV Посібник з монтажу - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник з монтажу для Кондиціонер AirStage ASUA14TLAV. AirStage ASUA14TLAV 15 сторінок. Indoor unit (wall mounted type)

Друкувати сторінку

L1, L2 (N):

Power supply

cable

Power supply

earth (ground)

cable

Earth (ground)

terminal for wired

remote controller

(if necessary)

Do not route the cables over the screw hole.

GOOD

Cable

Screw hole

When you attach the cable clamp, make sure that the cables are not jutting out from the

clamp or being pinched by the clamp.

(2) Install the cable clamp and piping cover.

Piping cover

En-13

X1, X2:

Transmission

cable

PROHIBITED

Cable

Screw hole

Piping cover

Screw

Cable clamp

Screw

7. FINISHING

After checking for gas leaks (refer to the Installation Manual of the outdoor unit),

perform this section.

Install heat insulation around both the large (gas) and small (liquid) pipes. Failure to

do so may cause water leaks.

(1) Insulate between pipes.

• For rear, right, and bottom piping, overlap the connection pipe heat insulation and

indoor unit pipe heat insulation and bind them with vinyl tape so that there is no

gap.

• For left and left rear piping, butt the connection pipe heat insulation and indoor unit

pipe heat insulation together and bind them with and vinyl tape so that there is no

gap.

Connection pipe

(Heat insulation)

Bind the pipes together so that

there is no gap.

Seal A is used when the diameter

of gas pipe is 1/2 inch or more.

Butt connection pipe (heat insulation) against the indoor unit pipe

(heat insulation) and wrap with seal A so that there is no gap.

• For left and left rear piping, wrap the area which accommodates the rear piping

housing section with cloth tape.

Pipe

Drain hose

• For left and left rear piping, bind the connection cable to the top of the pipe with

vinyl tape.

• For left and left rear piping, bundle the piping and drain hose together by wrapping

them with cloth tape over the range within which they ﬁ t into the rear piping

housing section.

(2) Temporarily fasten the connection cable along the connection pipe with vinyl tape.

(Wrap to about 1/3 the width of the tape from the bottom of the pipe so that water

does not enter.)

Connection cable –

Wall pipe

Drain hose

(3) Fasten the connection pipe to the outside wall with saddles, etc.

Saddle*

Pipe

(4) Fill the gap between the outside wall pipe hole and the pipe with sealer so that rain

water and wind cannot blow in.

(5) Install the front panel.

• First, ﬁ t the lower part of the front panel, and insert top and bottom hooks. (3 top

sides, 6 bottom sides)

CAUTION

Overlap the insulation

Indoor unit pipe

(Heat insulation)

Vinyl tape

Wrap with cloth tape

Cloth tape

Power supply cable

Transmission cable

Connection pipe

Outside wall cap*

Sealer putty*

Wall

(Outdoors)

*Field supply