Draper 03289 Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Дриль. Draper 03289. Draper 03289 16 сторінок. 18v cordless rotary drill

Друкувати сторінку

OPERATION AND USE

- FORWARD/REVERSE SELECTOR (Fig.4):

The switch determines the direction of rotation of the

chuck, i.e. clockwise or anticlockwise.

To alter the direction of rotation, stop the drill and push

switch (A) to the left or right. When the direction

switch is pushed to the left, the chuck will rotate

clockwise. When the switch is pushed to the right, the

chuck will rotate anticlockwise. Before operation, check

that the switch is set in the required position. Do not

change the direction of rotation until the chuck comes

to a complete stop.

When the drill is not in use move the direction switch to

the neutral position (the middle setting) to lock the

trigger out.

- TRIGGER:

When the trigger is depressed, the chuck will rotate

(provided the direction switch is set in the forward or

reverse position). This trigger switch is electronic which

enables the user to vary the speed continuously. The

speed varies according to how far the trigger switch is

depressed. The further it is depressed, the faster the

chuck will rotate. The lighter it is depressed, the slower

it will rotate.

- TORQUE CONTROL (Fig.5):

By turning the collar (B) it is possible to adjust the

amount of torque.

In the "twist drill" setting

full torque.

Settings 1-23 provide a facility for setting the torque to

the required level. For example, this means that

repetitive driving of screws of the same size will be

driven into the material to the same torque, thus giving

the same fixing strength, or in the case of countersunk

screws, these will all be driven to the same depth in the

material.

The torque control prevents the heads of small diameter

screws being twisted off when correctly set.

- CHANGING SPEEDS (Fig.6):

To change the speed of the chuck, slide the two speed

gearbox selection switch (C) forward for low speed

and backward for high speed.

- NOTE:

Do not switch between speeds whilst drill is being used.

This will cause damage to the drll gearbox.

, the drill/screwdriver has

- 8 -

FIG.4

FIG.5

(B)

FIG.6

(A)

(C)