Draper 14601 Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Дриль. Draper 14601. Draper 14601 20 сторінок. 18v li-ion cordless

BASIC CORDLESS ROTARY DRILL OPERATIONS

8.1 BATTERY CHARGING – FIGS. 1 – 2

To charge the battery pack

removed from the drill.

(i) To release the battery pack, press down on the

battery release button

front of the battery pack and gently pull the

battery pack away from the housing (Fig.1).

(ii) Slide the charger connector

connection block of the battery pack

then connect the charger's three pin plug into a

230V. electrical socket.

(iii) The red LED

illuminate solid and the green LED

extinguish to show that the battery is charging.

The battery will be fully charged after the 3-5 hour

charging period. The red LED will no longer illuminate

and the green LED will illuminate solid.

The battery pack and charger can then be seperated

and removed from the 230V supply. To refit the

battery pack to the drill, push firmly until the battery

pack locates and clips into place.

Warning: Do not exceed charging period this could

damage the battery. Overcharging the battery (more

than six hours) could damage the battery cells.

Note: The battery was discharged after manufacturing

and will therefore require five to ten charges/discharges before it reaches its full capacity.

Do not expose either the drill or charger to rain or water.

A correctly fitted dust mask, suitable for the activity and in accordance to the relevant

standard must be worn.

Swarf produced by metal drilling is extremely sharp. Take precautions when clearing swarf.

The burr left on the hole is also sharp and should be removed with a suitable tool.

Always wear safety goggles.

Warning: Drill bit will be hot after use.

, it must first be

located on the

onto the

on the charger will

FIG.1

and

will

FIG.2