Draper CSM355 Інструкція з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Пила. Draper CSM355. Draper CSM355 16 сторінок. 355mm dry metal cutting saw
Друкувати сторінку
TROUBLESHOOTING
WARNING:
Trouble
Motor does not start.
Brush sparking when
released.
Blade hits table.
Angle of cut not accurate.
Powerhead wobbles.
Cannot move mitre
adjustment
Power head will not rise
fully.
Blade binds, jams.
Tool vibrates or shakes.
IMPORTANT NOTICE: The blade is a consumable item, always allow the blade to cut freely. Do not force
the blade through the workpiece. This will result in poor cutting and damage to the TCT teeth.
The blade supplied is suitable for dry cutting mild steel and angle iron. It is not capable of cutting hard
steel or stainless steel. Certain materials will require the blade to be sharpened more frequently, for
example galvanised steel.
FOR YOUR OWN SAFETY ALWAYS TURN THE MAIN SWITCH ON THE
MACHINE "OFF" AND REMOVE THE PLUG FROM THE POWER SUPPLY
BEFORE CARRYING OUT ANY MAINTENANCE OR TROUBLESHOOTING.
Probable Cause
1. Fuse.
2. Brushes worn.
3. Other.
1. Normal - automatic brake
working properly.
1. Misalignment.
2. Damaged depth stop.
1. Misalignment.
1. Loose pivot points.
1. Fence in rear position and
clamp tight.
1. Pivot misadjustment.
2. Part failure.
3. Pivot spring not replaced
properly after service.
1. Improper operation.
2. Blunt blade.
3. Improper blade.
Warped blade.
1. Saw blade not round.
2. Saw blade damaged.
3. Saw blade loose.
4. Other.
Remedy
1. 13 amp time delay fuse or circuit
breaker. Fuse in plug.
2. See "Maintenance".
3. Authorised service agent.
1. See assembly and alignment.
2. Authorised service agent.
1. See "Operation & Use".
1. See "Operation & Use".
1. Loosen fence clamps, re-tighten
before starting next cut.
Vacuum out dust.
WEAR EYE PROTECTION.
1. See "Operation & Use".
2. Authorised service agent.
3. Authorised service agent.
1. See "Operation & Use".
2. Replace or sharpen blade.
3. Replace blade.
1. Replace blade.
2. Replace blade.
3. Tighten arbor screw.
4. Authorised service agent.
- 11 -