Draper 77759 Інструкція з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Повітряний компресор Draper 77759. Draper 77759 16 сторінок. 25 & 50 litre compressors

Друкувати сторінку

OPERATION AND USE

ADJUSTING THE PRESSURE SWITCH

(Fig.5):

(C)

Note: This is the only operation where it is

acceptable to switch the compressor off

(D)

without using the pressure switch.

To decrease the pressure switch, run the

compressor up to the desired capacity for the

pressure switch to be set. At this point, turn

the mains power off and do not operate the

red button on the pressure switch as this will

release the pressure. Disconnect the machine

from the power source before removing

cover (D). With this removed, the adjustment

Fig.5.

bolt (C) will be visible. Adjust this anti-

clockwise gently until the switch is heard to

release the pressure. Replace the cover and

tighten the screw. The switch will now be set

to the new pressure.

To increase the pressure switch, remove the

switch cover (having disconnected the

machine from the power supply) and turn the

adjustment bolt clockwise 3 turns and

replace the switch cover. Run the compressor

up to the desired capacity for the pressure

switch to be set (do not let the compressor

run past its maximum pressure). At this point

turn the mains power off and disconnect from

the supply. Remove the cover and adjust the

bolt anti-clockwise gently until the switch is

heard to release the pressure. Replace the

cover and tighten the screw. The switch will

now be set to the new pressure.

HOW TO ADJUST WORKING PRESSURE

(Fig.6):

See in the instruction manual for the rated

(G)

pressure value of the accessory you are going

to use.

By means of the pressure reducer (G) you

can adjust delivery air pressure. Turn the

knob clockwise to increase the pressure or

anti-clockwise to decrease the pressure.

Check the operating pressure value on

pressure gauge (F).

(F)

After having used your compressor, set

Fig.6.

pressure to zero by turning knob (G) so as to

avoid damaging the pressure reducer.

- 7 -