Draper 83420 Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для М'ясорубка Draper 83420. Draper 83420 20 сторінок. 150mm 150w

HEALTH & SAFETY INFORMATION

Wait for the machine to stop. Unless the machine is fitted with a safety brake; some parts may

continue to move due to momentum. Wait for all parts to stop; then unplug it from the power

supply before making any adjustments, carrying out maintenance operations or just finishing

using the tool.

Remove and check setting tools. Some machinery requires the use of additional tools or keys to

set, load or adjust the power tool. Before starting the power tool always check to make certain

they have been removed and are safely away from the machine.

Prevent unintentional starting. Before plugging any machine in to the power supply, make sure

the switch is in the OFF position. If the machine is portable; do not hold the machine near the

switch and take care when putting the machine down; that nothing can operate the switch.

Carefully select an extension lead. Some machines are not suitable for use with extension leads. If

the tool is designed for use outdoors; use an extension lead also suitable for that environment.

When using an extended lead, select one capable of handling the current (amps) drawn by the

machine in use. Fully extend the lead regardless of the distance between the power supply and the

tool. Excess current (amps) and a coiled extension lead will both cause the cable to heat up and

can result in fire.

Concentrate and stay alert. Distractions are likely to cause an accident. Never operate a power tool

if you are under the influence of drugs (prescription or otherwise), including alcohol or if you are

feeling tired. Being disorientated will result in an accident.

Have this tool repaired by a qualified person. This tool is designed to confirm to the relevant

international and local standards and as such should be maintained and repaired by someone

qualified; using only original parts supplied by the manufacturer: This will ensure the tool remains

safe to use.

5.2 SPECIFIC SAFETY INSTRUCTIONS FOR BENCH GRINDERS

ADDITIONAL SAFETY INSTRUCTIONS

Check the speed marked on the wheel is equal to or greater than the rated speed of the

grinder;

Ensure that the wheel dimensions are compatible with the grinder;

Abrasive wheels shall be stored and handled with care in accordance with manufacturer's

instructions;

Inspect the grinding wheel before use, do not use chipped, cracked or otherwise defective

products;

Ensure that mounted wheels and points are fitted in accordance with the manufacturer's

instructions;

Ensure that blotters are used when they are provided with the bonded abrasive product and

when they are required;

Ensure that the abrasive product is correctly mounted and tightened before use and run the

tool at no-load for 30 seconds in a safe position, stop immediately if there is considerable

vibration or if other defects are detected.

If this condition occurs, check the machine to determine the cause;

Never use the tool without a guard.

Do not use separate reducing bushings or adapters to adapt large hole abrasive wheels;

For tools intended to be fitted with threaded hole wheel, ensure that the thread in the

wheel is long enough to accept the spindle length;

Check that the work piece is properly supported;