Draper TopSpin Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Внутрішнє оздоблення приміщень Draper TopSpin. Draper TopSpin 3 сторінки.

Друкувати сторінку

Top Spin by Draper

The TopSpin

is shipped pre-loaded on the

roller assembly

DO NOT REMOVE PLASTIC WRAP UNTIL ROLLER ASSEMBLY IS INSTALLED IN SIDERAILS.

Assembly Assistant:

• Railing

• Loading

Plate

Figure

1 Insert the

into the

loading plates

and hand-tighten in place (see fig. 6).

railing

with t

2 Align

assembly assist rails

and insert

and hand tighten

loading plates

(see fig. 7).

onto the t

3 Push the

roller assembly

4 Move the

into desired position

roller assembly

and fasten the motor end of

roller assembly

the

siderails

CAREFULLY REMOVE THE PLASTIC WRAP

and

assembly assist siderails

Rope Installation

Once the

motor

end of the roller assembly

1 Remove the cover from top of Hem Bar and locate the Square holes on each

2 Pull both ends of the rope through the square hole located in between the Hem Bar Rollers.

3 Pull the

through the

rope

ropeblock

4 Tie the rope securely onto the screw (Fig. at right).

5 Pull the rope through the ropeblock as on the drawing with the provided special tool.

6 Assemble the ropeblock into the square hole.

7 Repeat on the opposite side

8 Assemble the spring between the two ropes and pull some tension on the spring.

a. Check if the rope is on the ride position on the rollers and the disks at both ends of the siderails.

b. Before straining the springs, place the sections into the final position on the siderail

and bolt the last tube.

c. Then stretch the spring till the length of 50cm and make a knot.

d. Adjust the motors (see motor manual) and test.

e. Check the spring length of 50cm and close the first profile.

9 The TopSpin system is now ready to use.

assembly assistant

TopSpin

Siderails

Roller Assembly

(Plastic Wrapped)

Hand-Tighten

Loading Plate

to Railing

MOTOR

assembly assistant

Roller Assembly

pin siderails

(Plastic Wrapped)

pin siderails

Assembly Assist

Siderails

is secured on the siderails, the pre-assembled rope in the siderail can be installed.

(Fig. at right) with provided special tool.

www.draperinc.com

Installing Roller Assembly

and is held secure with plastic wrap.

TopSpin

Siderails

Roller Assembly

onto Siderails

Roller Assembly

(Plastic Wrapped)

Assembly Assist

Siderails

Threading Ropeblock through Roller Assembly

(765) 987-7999

PUSH

Roller Assembly

onto Siderails

Roller Assembly

(Plastic Wrapped)

MOTOR

Assembly Assist

Siderails

Figure

Page 2 of 3

Roller Assembly

(Plastic Wrap Removed)

MOTOR

Attach

Last Roller to

Side Rails

Remove

Assembly Assist

Siderails