Bosch Benchmark HSLP451UC Інструкція з монтажу Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Духовка. Bosch Benchmark HSLP451UC. Bosch Benchmark HSLP451UC 32 сторінки. Built-in steam convection oven
Також для Bosch Benchmark HSLP451UC: Технічні характеристики (3 сторінок), Посібник з монтажу (26 сторінок), Посібник з монтажу (26 сторінок), Короткий довідник (4 сторінок)
Друкувати сторінку
7 Electrical connection
Electrical connection
Read these instructions to safely connect your appliance
Electrical connection
to the electrical supply.
7.1 Electrical requirements
Make sure your electrical installation supports the follow-
ing requirements.
WARNING
IMPROPER GROUNDING CAN RESULT IN A RISK OF
ELECTRIC SHOCK.
Consult a qualified electrician if the grounding instruc-
▶
tions are not completely understood, or if doubt exists
as to whether the appliance is properly grounded.
If the power cord is too short, have a qualified electri-
▶
cian install an outlet near the appliance.
DO NOT USE AN EXTENSION CORD.
▶
Electrical supply
Circuit breaker
Conduit
Electrical rating
¡ Circuit specifications: 208/240V AC, 60Hz, 15A, 3- wire,
dedicated grounded circuit from panel.
¡ The outlet must be properly grounded in accordance
with all applicable codes.
¡ It is the responsibility of the installer to comply with local
codes. If no local codes are applicable, wire in accor-
dance with the National Electrical Code (or Canadian
Electrical Code), ANSI/NFPA 70 - latest edition.
¡ Minimum bend radius of the flexible conduit is 6'' (152
mm).
¡ The electrical supply should be a 3-wire single–phase
AC. Install a suitable junction box (not furnished).
¡ IMPORTANT: Local codes may vary; installation, elec-
trical connections and grounding must comply with all
applicable local codes.
208/240V AC, 60Hz, 3–wire
15 Amp
48" flexible 3-wire
1.43 kW @ 208V
1.9 kW @ 240V
7.2 Installing a three-wire connection
To facilitate serviceability and to ensure the safety of
1.
the installation, the flexible conduit must not be short-
ened and should be routed to allow for temporary re-
moval of the oven.
1
2
3
4
Cable from home power supply
1
Red wires
2
Green (or bare) ground wire (from oven)
3
3-wire flexible conduit from oven
4
Junction box
5
Black wires
6
UL listed or CSA approved conduit connector
7
Pull the wires through the knockout hole.
2.
Snap the strain relief into place.
3.
Connect the red wire from the oven to the red wire in
4.
the junction box (hot wire).
Connect the black wire from the oven to the black wire
5.
in the junction box (hot wire).
Connect the yellow/green ground wire from the oven to
6.
the bare or green ground wire in the junction box.
8 Customer Service
Customer Service
If you have any questions on use, are unable to eliminate
Customer Service
an issue in the appliance yourself, or the appliance needs
to be repaired, please contact our Customer Service.
With any warranty repair, we will make sure your appli-
ance is repaired by an authorized service provider using
genuine replacement parts. We use only genuine replace-
ment parts for all repairs.
Detailed information on the warranty period and terms of
warranty can be found in the Statement of Limited Product
Warranty, from your retailer, or on our website.
Electrical connection en-us
5
6
7
9