Bosch Benchmark Series Посібник з експлуатації - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Духовка. Bosch Benchmark Series. Bosch Benchmark Series 36 сторінок. Built-in wall ovens
Також для Bosch Benchmark Series: Посібник з монтажу (32 сторінок), Короткий довідник (4 сторінок), Посібник з експлуатації (45 сторінок), Інструкція з монтажу Посібник з монтажу (40 сторінок), Посібник із швидкого запуску та техніки безпеки (13 сторінок)
Друкувати сторінку
58300000187895 ARA EN A
Figure 17 HTC and mounting bracket
7.3.1 Resetting and Replacing the HTC
Always troubleshoot a tripped HTC to determine the underlying cause
of the interruption.
To reset the HTC...
1. Remove power to the range.
2. Insert a flat blade screwdriver through one of the vent slots,
and depress the red reset button.
3. Restore power and test operation.
NOTICE
The HTC switch should only be reset once or twice before replacing.
The switch weakens each time it trips, so it will become easier and
easier for the switch to trip during high-temperature cycles (i.e., Self-
clean) if it has weakened over time.
To remove the HTC from the front, a right-angled screwdriver will be
needed....
1. Remove power to the range.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2015
2. First remove the latch plate and remove or slide the
latch/motor assembly aside as described in the Replacing the
Latch/Motor Assembly section.
3. Using a right-angled screwdriver, remove the two screws
securing the HTC to its mounting bracket.
4. Disconnect the wires and remove the HTC.
5. Install the new HTC.
6. Reinstall or reposition the latch motor assembly.
7. Reinstall all parts, reconnecting wires, as necessary (refer to
the Service Guide (wire diagram) attached to the rear vented
housing panel for reference.
8. Restore power and test operation.
7.4
The control panel service assembly includes...
Stainless front panel with gasket along inside bottom edge
Touch panel assembly: white LED touch panel assembly with
touch control module (TCM)
Figure 18 Control panel service assembly
The TCM is an electronic module which monitors, qualifies, and
transmits the inputs from the touch panel to the control module. After
start-up, the control module polls the TCM every 100ms to determine
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges
Control Panel
Page 18 of 36
800 944-2904