Bosch HB 63 Series Інструкція з експлуатації - Сторінка 15
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Духовка. Bosch HB 63 Series. Bosch HB 63 Series 28 сторінок.
Друкувати сторінку
Hook the seal in to the bottom of the panel again (fig. D).
4.
Insert the uppermost panel at an angle to the back into the
5.
brackets. Take care not to push the seal to the back (fig. E).
Troubleshooting
Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.
Troubleshooting table
Fault
Possible cause Solution/advice
The oven does
The fuse has
not work.
blown.
Power cut.
Power cut.
lights up on
0
the display with
some zeros.
The oven does
There is dust on
not heat up.
the contacts.
The oven door
The oven door
does not open.
has been locked
by the self-
The
symbol
L
cleaning
lights up on the
function
display panel.
The oven does
The oven is in
not heat up.
demo mode.
The two points
on the display
panel flash.
The display
The appliance
has been auto-
shows
"‰
.
matically turned
off.
Check the condition of the
fuse in the fuse box.
Check that the light in the
kitchen and other house-
hold appliances are work-
ing.
Set the time once again.
Turn the control knobs sev-
eral times in both direc-
tions.
Wait until the oven has
cooled and the
L
turns off.
.
q
Disconnect the fuse from
the fuse box and reconnect
after around 20 seconds.
Then, within around
2 minutes, press the
button for approx.
4 seconds until the two
points stay lit.
Turn the function control
knob to the zero setting.
Insert the two small seals on the left and right of the panel
6.
again (fig. F).
Put the cover back in place and screw it on.
7.
Attach the oven door.
8.
Do not use the oven again until the panels have been
correctly installed.
Error messages
When the display panel shows an error message with
the
0
button. The message will disappear. The set time
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
Error message Possible cause Solution/advice
"‹‚‚
"‚‹‡
"‚‚†
symbol
:
Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical Support
Service.
D
A button has
Press all of the buttons one
been pressed
by one. Check if any button
for too long or
is stuck, covered or dirty.
has got stuck.
The door lock
Press the
has been acti-
can now begin program-
vated with the
ming again.
door open.
The tempera-
The oven door is locked
ture inside the
and heating has stopped.
oven is too
Wait until the oven has
high.
cooled. Press the
ton and reset the time.
"
, press
0
button. You
but-
0
15