Electrolux 400 SERIES Інструкція з монтажу Посібник з монтажу - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Пральна машина Electrolux 400 SERIES. Electrolux 400 SERIES 50 сторінок. Front load dryer
Також для Electrolux 400 SERIES: Посібник з використання та догляду (16 сторінок), Посібник з використання та догляду (39 сторінок), Посібник з використання та догляду (28 сторінок), Посібник з використання та догляду (46 сторінок)

12 Reversing Door

Door reversibility is available only on 500, or 600 series models.

BEFORE YOU REVERSE WASHER DOOR:

1. Be sure you have adequate swing area

before reversing door.

2. Gather your tools - including a screw driver

with a #2 square bit and plastic knife (or small,

flat prying tool that won't damage paint).

3. Protect flat work surface, such as top of

washer or floor near washer, with a soft

cloth or towel.

4. Be sure washer is unplugged from power

source!

Failure to disconnect power source before servicing could result in personal injury or

even death.

Removing Door Assembly

1. Completely open the door to expose all

four hinge screws.

2. Remove all four hinge screws with #2

square bit driver. Save for reinstalling later.

Fine Thread

3. Hold the door with one hand sup-

porting the handle area and one hand

supporting the hinge. While supporting

the door at the hinge, press firmly with

the other hand until the locating pins

on the back of the hinge plate dislocate

from the front panel.

NOTE

IMPORTANT

WARNING

ELECTRICAL SHOCK HAZARD

Tools needed for reversal:

4. While supporting the door with one

hand, pinch the tabs to release the plas-

tic terminal cap from the hinge plate.

IMPORTANT

Take care not to pull the door away from

the washer until you remove the wiring

harness terminal cap.

5. Set the door face down on a flat sur-

face protected by soft cloth or towel.

Screwdriver

with #2

square bit

Plastic knife