Bosch HBB56 2 Series Інструкція з експлуатації - Сторінка 13
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Духовка. Bosch HBB56 2 Series. Bosch HBB56 2 Series 36 сторінок.
Друкувати сторінку
Press the
X
button.
3.
Change the basic setting using the control knob.
4.
Automatic shut off
This oven has an automatic shut-off function. This function is
activated when no cooking time has been specified and the
configuration has not changed for a long time. This depends on
the temperature or grill power selected.
Automatic shut-off activated
The display panel turns on
Cleaning function
The cleaning function regenerates the self-cleaning surfaces
inside the oven.
The inside rear and side walls and ceiling of some ovens may
be lined with a highly porous ceramic lining. This lining absorbs
splashes produced during baking and roasting, dissolving them
while the oven is on. This cleaning system makes it possible to
regenerate self-cleaning surfaces that can not properly clean
themselves.
As an option, self-cleaning side walls can be purchased as
special accessories from the Technical Assistance Service, by
quoting part number 439083 and 439084.
The clean function can be used when the oven is equipped with
a self-cleaning back wall and self-cleaning side walls. This
function intensifies the regeneration process for the self-
cleaning walls.
Changing the basic settings
Once the side walls have been installed, activate the clean
function using the basic settings. See the Basic settings
chapter to find out how to do this.
Cleaning levels
There are three cleaning levels available.
Level
Cleaning level
mild
‚
medium
ƒ
intense
„
Before cleaning
Remove all pans and unsuitable accessories from inside the
oven.
Cleaning the oven's base and enamelled walls
Before programming the clean function, clean the surfaces
inside the oven that are not self-cleaning. Otherwise, stains will
appear that are impossible to remove.
Use a cleaning cloth and hot water with a little soap or vinegar.
If very dirty, use a fine steel scourer or a special oven cleaning
product. These must only be used when the oven interior is
cold. Do not use metal scourers or special oven cleaning
products on self-cleaning surfaces.
. The oven will pause operation.
"‰
Duration
approx. 45 minutes
approx. 1 hour
approx. 1 hour, 15 minutes
Now you can change other basic settings, as described in
5.
points 2 to 4.
Press the
button until the time is displayed. Wait for
°
6.
approximately four seconds. All changes are saved
Cancelling
Press the
button. The changes are not applied.
%
Press any key to turn off the indicator. You can now begin
programming again.
Note: If a cooking time has been set, the oven stops heating
when this time has elapsed. The automatic shut-off is not
required.
Setting the cleaning level
Press the
button.
p
1.
The cleaning level 3 is displayed. Cleaning can be started
directly with the
button.
n
If you wish to change the cleaning level:
Select the cleaning level with the control knob.
2.
Begin cleaning by pressing
3.
Once cleaning has finished
The oven stops heating.
‹‹
Cancelling the settings
Hold down the
button until the 3D hot air symbol
n
temperature of 160 °C are displayed. You can now reprogram.
Adjusting the cleaning level
Once cleaning starts, the cleaning level can no longer be
changed.
Cleaning must take place at night
Cleaning can be programmed at night so the oven is available
during the day.See the Time functions chapter, delay cooking
time.
After cleaning
Once the inside of the oven has cooled, clean the ash remains
from the self-cleaning surfaces using a damp cloth.
.
n
:
appears in the display.
‹‹
<
and a
13