Draytek vigorswitch p1090 Посібник із швидкого старту - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Перемикач Draytek vigorswitch p1090. Draytek vigorswitch p1090 4 сторінки. 8 gigabit port poe switch
Друкувати сторінку
Installing Your Switch
Power Device to This Switch and Getting 48V Power Source through
Cat. 5 Cable
Use a Cat. 5 twisted-pair cable to connect a PoE device to the port (1~8) of this
switch. The switch will supply 48V power to PoE Device over the twisted-pair
cable. Please note that Power Device must comply with IEEE 802.3af/at. Other
PCs, servers and network devices can be connected to the switch using a
standard 'straight through' twisted pair cable.
The switch can be installed
easily by using rack mount
kit. However, due to
environmental limitation,
the wall-mount installation
might be required. Simply
follow the steps below:
1. The two slots located on
the switch's bottom
panel are for device
wall-mount use. The
distance between the two
slots is 7.8 inches
(198.02 mm). Attach two
screws on the wall, so
that the switch's
wall-mount slots line up
with the two screws.
2. Use drill bit to insert the two
plastic screws into the wall.
3. Insert the two iron screws into the
hole of the two plastic screws
respectively.
4. Place the switch onto the iron
screws through the wall-mount
slots to make the switch hanging
on the wall.