Electrolux EW 1013I Інструкція з експлуатації - Сторінка 17
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Пральна машина Electrolux EW 1013I. Electrolux EW 1013I 28 сторінок.
Друкувати сторінку
132984330.qxd
21/07/2005
10:19
Unscrew and remove the filter.
Clean carefully under a fast running tap.
Warning
When the appliance is in use and depending on the
programme selected there can be hot water in the filter.
Never remove the filter during a wash cycle, always
wait until the appliance has finished the cycle, and is
empty. When replacing the filter, ensure it is securely
retightened so as to stop leaks and young children being
able to remove it.
Cleaning the water inlet filter
If your water is very hard or contains traces of lime
deposit, the water inlet filter may become clogged.
It is therefore a good idea to clean it from time to time.
Turn off the water tap. Unscrew the water inlet hose.
Clean the filter using a hard bristle brush.
Tighten up the inlet hose.
Pagina
17
(Nero/Process Black pellicola)
17
The dangers of freezing
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
Turn off the water tap.
●
Unscrew the inlet hose.
●
Unhook the drain hose from the rear support and
●
position the end of this hose and that of the inlet
hose in a bowl. Run the draining programme "P".
Disconnect the appliance.
●
Screw the inlet hose and reposition the drain hose.
●
When you intend to start the machine up again,
●
make sure that the room temperature is above 0°C.
Emergency emptying out
If the water is not discharged, proceed as follows to
empty out the machine:
pull out the plug from the power socket;
●
close the water tap;
●
if necessary, wait until the water has cooled down;
●
Unscrew and remove the filter;
●
place a bowl on the floor. The water should drain by
●
gravity into the bowl. When the bowl is full, empty
the bowl. Repeat the procedure until water stops
flowing out;
clean the filter if necessary as previously described;
●
screw the filter again.
●