Bosch HBG38B9 0 Series Інструкція з експлуатації - Сторінка 18
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Духовка. Bosch HBG38B9 0 Series. Bosch HBG38B9 0 Series 40 сторінок.
Друкувати сторінкуRemoving and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
1.
Detach the oven door and lay it on a cloth with the handle
facing down.
Unscrew the cover at the top of the oven door. To do this,
2.
undo the left and right screws (fig. A).
Lift the top panel up and out (fig. B).
3.
$
Unscrew the retaining clips on the right and left. Lift the panel
4.
and remove the brackets from the panel (fig. C). Take out the
panel.
&
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Problem
The appliance does not work.
The text "Time 00:00" appears in the dis-
play. The time is not the current time.
The oven does not heat up or the type of
heating selected cannot be set.
The oven does not heat up. The text
"Demo" is displayed.
A reference to the cleaning system
p
appears when the
button is pressed.
"Automatic switch-off" appears in the dis-
play.
18
%
Possible cause
Faulty circuit breaker
Power cut
Type of heating not recognised
The oven is in demo mode.
The appliance is not equipped
with the cleaning system.
Automatic switch-off has been
activated. The oven switches off.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left.
Insert the panel diagonally towards the back (fig. A).
1.
2.
Stick the retaining clips onto the right and left-hand sides of
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. B).
$
Insert the uppermost panel diagonally towards the back. The
3.
smooth surface must face outwards.
Put the cover back in place and screw it on.
4.
Attach the oven door.
5.
Do not use the oven again until the panels have been
correctly fitted.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Note/remedy
Look in the fuse box and check that the circuit
breaker is in working order.
Set the current time and press the
Make the settings again.
Switch off the circuit breaker in the fuse box and
then switch back on after approx. 20 seconds. In
the next 2 minutes hold the
four seconds until the text "Demo" disappears.
The button only works if you retrofit the self-clean-
ing ceiling and the side components and subse-
quently activate the cleaning system in the basic
settings. See the Cleaning system section and the
Basic settings section.
Press any button. The text disappears. You can
make settings again.
%
0
button.
D
button down for