Carl Wittkopp GatorSignal Plus Інструкція з монтажу - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Обладнання для запису Carl Wittkopp GatorSignal Plus. Carl Wittkopp GatorSignal Plus 8 сторінок.

Друкувати сторінку

7.4 Internal assignment input

• Both inputs are made as diode lines for optocouplers.

• To simplify the assignment of potential-free contacts the supply voltage was bridged to additional.

Lock

• max. input voltage 12 VDC

• medium current consumption ca. 10mA

7.4.1 Internal assignment output

• When operating in mixed mode with batteries, they are "divided" electronically by mixing diodes as soon as the motor

voltage is higher than the open-circuit voltage of the battery (9V) – unnecessary discharging is avoided.

• All outputs are made as changeover contacts of a relay.

• The base contact (com) leads to a solder contact for a row resistor i.e. for a direct evaluation within an alarm circle by a

burglar alarm system.

• When using the changer as switch, either solder a jumper at this place or use the asigned solder jumper.

• The marking of the solder jumpers are numbered like the corresponding output relays:

- J1 and R1 correspond to relay Q1

- J2 and R2 correspond to relay Q2

- J3 and R3 correspond to relay Q3

- J4 and R4 correspond to relay release switch (sabotage)

7.5 Activate/deactivate I/Os

• The in-/output functions have tob e activated in the software GatorSelect or the input unit with the according access rights

before using them.

Abbreviated dialling

*30*

*31*

Installation instruction GatorSignal Plus

Activate I/O

Deactivate I/O