Alemlube EL SERIES Технічний посібник користувача - Сторінка 4

Plastic Spring Driven Reel 2766 Series Instruction

Operation

1. Check reel for correct operation by slowly pulling out the hose.

2. To latch the reel, pull out the hose about 3 feet/1m and allow it to retract until the hose

stops retracting.

3. To unlatch the reel, slowly pull out the hose about 1 foot/0.3m then let the hose retract

until the hose stopper rests against the hose guide opening.

Note: To avoid damage to the reel, always hold on to the hose while it is rewinding.

4. Periodically check the hose condition for wear or damage, and check the swivel fitting

for leakage. Replace any worn, damaged, or leaking parts.

Make sure the hose is in proper working order.

Clean the hose with a cloth dipped in warm water to remove dirt or deposits and ensure

correct rewinding.

Do not use detergents or solvents which could prove incompatible with cable-winder materials.

Dismantling of the unit by unskilled personal could prove hazardous; the risk involved mainly

concern the preloaded springs.

1. The manufacturer warrantees this hose reel against defects in material and craftsmanship,

for a period of 24 months from date of purchase, but not including hose and O-ring parts.

2. Manufacturer's liability is limited to replacement or repair of defective material within the

warranty period, when returned freight prepaid to the distributor or their designated

service depot.

3. The warranty does not cover damage caused by accident, misuse or faulty installation.

4. The reel must be installed and maintained in compliance with the instructions.

NSW

QLD/PNG

TEL: (02) 9677 1555

TEL: (07) 3204 9166

FAX: (02) 9675 1155

FAX: (07) 3204 1224

Visit our website at

EL 40000 Series Instruction

3 OF 4

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

www.alemlube.com.au

SA/NT

TEL: (08) 9302 4199

TEL: (08) 8241 7111

FAX: (08) 9303 2095

FAX: (08) 8241 7011

www.alemlube.co.nz

TEL: (64) 9 447 1007

FAX: (64) 9 447 1008