58300000194725 ARA EN B
7
SERVICE AND REPAIR: COOKTOP
WARNING
!
To avoid possible electric shock or gas explosion, be sure electrical
and gas supplies to the cooktop are shut off before servicing.
If testing the appliance requires the use of electrical power and/or an
open gas supply, exercise extreme caution.
7.1
Replacing Burners and Burner Bases
1. Disconnect power to the range and turn off main gas supply.
2. Remove all grates by lifting them up from the cooktop.
3. Remove burner caps.
4. Remove and retain two (2) # 8 - ¾ T20 Torx screws from each
burner base, and carefully lift burner base up from the
maintop.
Figure 36 Removing burner base
5. Install the new burners.
6. Reassemble, restore power and gas, and test operation.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2016
7.2
Spark igniters are available separately or included with jet holders.
Figure 37 View of jet holder assembly and igniter (electrode)
1. Disconnect power to the range and turn off main gas supply.
2. Remove maintop.
The igniter is ceramic and can be brittle; handle with care.
3. Remove the screw securing the igniter to the jet holder and lift
out the igniter.
4. Carefully pull the igniter wire from the spark igniter.
5. Install the new igniter.
6. Reassemble, restore power and gas, and test operation.
7.3
1. Disconnect power to the range and turn off main gas supply.
2. Remove burner caps and burners.
3. Remove maintop.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Gas Slide-in Ranges
Replacing Spark Igniters
NOTICE
Replacing Spark Switch Harness
Page 27 of 36
800 944-2904
Друкувати сторінку