Anchor AN-130 Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Anchor AN-130. Anchor AN-130 8 сторінок. Portable public address sound system
Також для Anchor AN-130: Технічні характеристики (1 сторінок), Брошура та технічні характеристики (2 сторінок), Каталог (2 сторінок), Посібник користувача (4 сторінок)

Друкувати сторінку

Diversity Wireless by Anchor Audio

Anchor Audio UHF wireless is a 16 channel, diversity wireless

system that utilizes two independent antennae to receive signal. The

diversity feature means that the receiver will process the stronger of

the two antenna signals, effectively minimizing dropouts and

interference from other transmitting sources. The antennae are

mounted internally so there are no obstructions or risk of damage.

Wireless Microphone Operation

Both the receiver and microphone must be set to the same channel.

NOTE:

When using

1. If you are using a body-pack transmitter, insert the plug from

more then

the mic into the jack marked MIC on the transmitter.

one wireless

unit, make

2. Turn the transmitter power switch to ON.

sure each

(The red LED will flash when the mic is turned on.

microphone

If the red LED stays on, the battery is low.)

is set to a

3. Turn the AN-130U1 power switch to ON.

different

4. The RX indicators will light (one indicator at a time lights)

channel

when the wireless signal is being transmitted and received.

frequency.

WIRELESS OPERATION

Receiver Channel Selection

Before you use your UHF wireless system,

NOTE:

you will need to select a wireless frequency

If you are

experiencing

channel. The wireless receiver is mounted

ongoing

inside the AN-130U1 and can be set to any

interference

of 16 available channels.

with your

1. Locate the Wireless Channel selector on the back panel.

wireless

system, the

2. Using the selector knob set the frequency of the receiver

selected

to channel 1 thru 16.

frequency

may be

Transmitter Channel Selection

incompatible

Handheld Transmitter:

with other RF

systems in

1. Unscrew battery cover on

your area.

lower end of microphone.

Try a different

2. Set the channel selection

channel.

dial to match the channel

setting on the receiver.

3. Replace the battery cover.

Body-pack Transmitter:

NOTE:

1. The channel selection dial

Be sure that

is located on the side of

the MIC/LINE

the transmitter.

switch is in

2. Set the channel selection

the "MIC"

dial to match the channel

position when

setting on the receiver.

a mic is

plugged into

the TX.

WIRELESS OPERATION