Anchor AN-130U1 Посібник користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Anchor AN-130U1. Anchor AN-130U1 8 сторінок. Anchor an-130: technical spec
Також для Anchor AN-130U1: Посібник користувача (4 сторінок), Брошура та технічні характеристики (2 сторінок), Технічні характеристики (1 сторінок)
Друкувати сторінку
Diversity Wireless by Anchor Audio
Anchor Audio UHF wireless is a 16 channel, diversity wireless
system that utilizes two independent antennae to receive signal. The
diversity feature means that the receiver will process the stronger of
the two antenna signals, effectively minimizing dropouts and
interference from other transmitting sources. The antennae are
mounted internally so there are no obstructions or risk of damage.
Wireless Microphone Operation
Both the receiver and microphone must be set to the same channel.
NOTE:
When using
1. If you are using a body-pack transmitter, insert the plug from
more then
the mic into the jack marked MIC on the transmitter.
one wireless
unit, make
2. Turn the transmitter power switch to ON.
sure each
(The red LED will flash when the mic is turned on.
microphone
If the red LED stays on, the battery is low.)
is set to a
3. Turn the AN-130U1 power switch to ON.
different
4. The RX indicators will light (one indicator at a time lights)
channel
when the wireless signal is being transmitted and received.
frequency.
6
WIRELESS OPERATION
Receiver Channel Selection
Before you use your UHF wireless system,
NOTE:
you will need to select a wireless frequency
If you are
experiencing
channel. The wireless receiver is mounted
ongoing
inside the AN-130U1 and can be set to any
interference
of 16 available channels.
with your
1. Locate the Wireless Channel selector on the back panel.
wireless
system, the
2. Using the selector knob set the frequency of the receiver
selected
to channel 1 thru 16.
frequency
may be
Transmitter Channel Selection
incompatible
Handheld Transmitter:
with other RF
systems in
1. Unscrew battery cover on
your area.
lower end of microphone.
Try a different
2. Set the channel selection
channel.
dial to match the channel
setting on the receiver.
3. Replace the battery cover.
Body-pack Transmitter:
NOTE:
1. The channel selection dial
Be sure that
is located on the side of
the MIC/LINE
the transmitter.
switch is in
2. Set the channel selection
the "MIC"
dial to match the channel
position when
setting on the receiver.
a mic is
plugged into
the TX.
WIRELESS OPERATION
7