Dreadbox Smashing Tremolo Treminator Посібник - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник для Музична педаль Dreadbox Smashing Tremolo Treminator. Dreadbox Smashing Tremolo Treminator 3 сторінки.
Друкувати сторінкуA. Send an audio signal or an instrument to the input
B. Send the output to an amp or a monitor
C. Power the effect by using a 9VDC center negative power adapter (specialized for effect pedals)
D. Press the ON button to engage the effect
E. Then set an initial preset as followed:
RATE = 50%
SHAPE = triangle
This should result into a "normal" 1 sec tremolo effect. Start from here and try to experiment with the rest of the functions.
In order to enable the secondary controls, press and hold down the ON button. While this is on hold, you have access to different parameters.
If you'd like to save the secondary functions' settings, press and hold ON+TAP for 3 seconds. The LEDs will flash, indicating that this state is saved and the next
time you power the pedal, you will have it as you left it.
FADE = 50% (that is off actually)
THRESHOLD
RATE
EXPRESSION
RESET
HOLD
DOWN
SHIFT
DEPTH = 50%
DIVISIONS = 1 (left)
These are the SHIFT controls, that you can access while holding down
the ON button. Remember, in order to store this so that the pedal remem-
bers them the next time you power it, you must press and hold both
footswitches for 3 seconds!
RATE = THRESHOLD
Controls the signal to gate function. For more info about signal to gate,
check the "FADE AND EXPRESSION" chapter.
SHAPE = RESET
This controls if the Waveform of the LFO will be reset whenever a signal
EXTRA DIV
to gate appears. When at 0-49% sets the LFO waveform reset OFF. At
50-100% sets the LFO waveform reset ON. For more info about LFO
waveform reset check the "FADE AND EXPRESSION" chapter.
FADE = RATE EXPRESSION
This acts as the LFO speedup (0-49%), or slowdown function (51-100%).
At 50% travel this is set to off. For more info about speed expression
check the "FADE AND EXPRESSION" chapter.
RATE EXPRESSION
AMOUNT
DEPTH = RATE EXPRESSION AMOUNT
Sets the amount of speedup/slowdown. For more info about speed
expression check the "FADE AND EXPRESSION" chapter.
DIV toggle switch: extra divisions over the LFO rate. Its x1 , x2 , x4. Those
are multiplied to the main DIV selection, allowing for many combinations
and up to a x16 multiply over the rate control.