Anchor MegaVox Pro MEGA-8000X Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Anchor MegaVox Pro MEGA-8000X. Anchor MegaVox Pro MEGA-8000X 10 сторінок.
Друкувати сторінку
MegaVox Pro Public Address System Owners Manual
CONNECTING TWO OR MORE MEGAVOX PRO PA SYSTEMS
UNPOWERED MEGAVOX PRO COMPANION SPEAKER (MEGA-8001)
Connect one end of a speaker cable (SC-50) to the SPKR OUT jack on the back of a
powered MegaVox PRO PA system.
The other end connects to the jack labeled IN on the back of a MegaVox PRO
unpowered companion speaker.
NOTE: AC power is not required for an unpowered companion speaker.
POWERED MEGAVOX PRO PA SYSTEMS WITH LINE OUT
Connect speaker cable (SC-50) from LINE OUT on first powered MegaVox PRO to
LINE IN on second powered MegaVox PRO. Set volume level of the second system to
maximum, this gives full volume control to the first or primary PA system.
DAISY-CHAINING
Use the Line Out method above to connect up to six powered MegaVox PRO PA
Systems. Make all connections with power off.
Set volume level to maximum on all secondary systems so the primary unit Level
Control sets the volume for the entire chain.
To avoid speaker popping, which can cause damage, power speakers on in order,
primary unit first, and power speakers off in reverse order, primary unit last.
FIRST POWERED MEGAVOX PRO
SIGNAL ALERT
MIC 1
19 VDC
(60 WATTS MAX)
MegaVox Pro Bluetooth Back Panel Silkscreen Artwork
(Reference dwg# 216-0309-000 for dimension & material info)
Anchor Audio, Inc.
EX-50PP CABLE
PAIRING
RX
WIRELESS 1
8000
RX
WIRELESS 2
PAIRING
RX
RX
WIRELESS 1
RX
RX
SIGNAL ALERT
MIC 1
WIRELESS 2
MIC 2
LINE IN
LINE OUT
19 VDC
(60 WATTS MAX)
800.262.4671
MegaVox Pro Bluetooth Back Panel Silkscreen Artwork
(Reference dwg# 216-0309-000 for dimension & material info)
Anchor Audio, Inc.
SECOND POWERED
800.262.4671
MEGAVOX PRO
217-0309-000 rev. E
July 30, 2014
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
CORRECT SYSTEM PLACEMENT
CONTROLLING FEEDBACK
Feedback, a howling noise or shrill sound, is self-generated by the sound system. It's caused by
a microphone picking up the sound coming from the speaker and then re-amplifying it. Once a
feedback loop starts, it continues until the system is adjusted.
FEEDBACK CAUSES
• Microphone too close, pointing towards
or in front of speaker
• Volume setting is too loud for room
• Sound reflecting off hard surfaces
AVOIDING & ELIMINATING FEEDBACK
8000
• Point microphone in a different direction
RX
• Keep microphone away from the speaker
RX
• Place speaker in FRONT of the microphone
• Reduce the sound system volume levels
MIC 2
LINE IN
LINE OUT
CAUTION: Feedback can damage your equipment & may be hazardous to hearing.
217-0309-000 rev. E
July 30, 2014
MADE IN USA
SIX YEAR WARRANTY
WRONG SYSTEM PLACEMENT
3