Anchor MiniVox Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Anchor MiniVox. Anchor MiniVox 7 сторінок. Portable sound system
Також для Anchor MiniVox: Посібник користувача (4 сторінок), Посібник із швидкого старту (2 сторінок), Посібник користувача (10 сторінок)
Друкувати сторінку
Wireless Operation
Replacing the transmitter battery
Note: The transmitter power switch must be in the OFF position!
HANDHELD: Unscrew the battery compartment cover on
the lower end of microphone. Install a fresh 'AA' alkaline
battery and replace the cover.
Observe proper
BODY-PACK: Open battery cover
polarity when
installing the
on the side of the transmitter box
battery!
and insert a fresh 9 Volt alkaline
battery. Close the cover.
Operating the wireless microphone system
1. Set the MiniVox down and direct toward audience.
(Position the MiniVox in front of you while using the
wireless microphone to avoid feedback.)
2. Turn the MiniVox power/volume control ON about
halfway (red LED should begin flashing).
3. Turn the wireless microphone ON as follows:
Handheld: Set the switch to the top ON position and
begin speaking. The middle STANDBY position
functions as a mute switch.
CollarMic, Headband or Lapel Mic: Plug mic cable
into transmitter. Set power/frequency switch to the
frequency of the receiver (either F1 or F2) and begin
speaking.
NOTE: When the mic/transmitter is turned ON and
the transmitter frequency matches the receiver, the RF
Signal Indicator on the MiniVox should light steadily
(indicating signal is being received). If it does not light
steadily, review the instructions above and the
troubleshooting section on the back page.
4. Adjust volume control on MiniVox.
Caution: Harmful feedback may occur when walking in
front of a sound system or speaker with a wireless
microphone. Always point mic away from speakers.
8
(model PB-25W only)
Operation
MiniVox Control Panel
Power Indicator
OFF
CD / TAPE Input
model PB-25
(mini jack, 3.5mm)
CD⁄TAPE
(LINE LEVEL)
Microphone Input
MICROPHONE
with phantom power
(PHANTOM POWER)
(mini jack, 3.5mm)
CHARGER
AC-25 Charger Input
(sub-mini, 2.5mm)
MIC
CD⁄ T APE Input
Use the CD⁄TAPE input to play pre-recorded material through the
MiniVox. The volume control of the MiniVox controls both the
audio source and microphone when used simultaneously.
• Connect a mini-to-mini patch cable (3.5mm plugs) to
the 'Headphone' or 'Line' output of your audio
source and the CD ⁄ TAPE jack of the MiniVox.
• Turn the MiniVox ON and set the volume control to
about the 2 o'clock position. Then adjust the volume
control of the audio source to desired level.
Headphones
Headphones
Shielded
patch
Headphone output
cable
jack of audio source
Power Switch and
Volume Control
Lo-Z Mic Input
(1/4" phone jack)
Solid = Transmitter On
OFF
model PB-25
CD⁄TAPE
(LINE LEVEL)
CD⁄TAPE
(LINE LEVEL)
MICROPHONE
(PHANTOM POWER)
CHARGER
CD ⁄ TAPE Input
jack of MiniVox
MIC
5