Anchor Economy Tent 40 CLASSIC PLUS Інструкція з монтажу Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Намет Anchor Economy Tent 40 CLASSIC PLUS. Anchor Economy Tent 40 CLASSIC PLUS 8 сторінок. Frame tents

Друкувати сторінку

40'

CLASSIC PLUS FRAME TENTS

EAVE ASSEMBLY

Beginning in a corner slide the Side Eave

Bars over the pre-positioned Corner, Mid-Leg

Rafter, and 6-Way Mid-Leg Rafter fittings.

Lock them into place using the snap buttons

creating a ridged perimeter.

After completing the eave build place your 10'

step ladder in the center of the frame 20' in

from the end. This will be used to help support

the crown weldment during rafter assembly.

RAFTER / PEAK ASSEMBLY

While still on the ground and at the first 6-Way

Mid-Leg/Rafter Fitting location on the 40'

side attach one end of the 21'8" Double

Truss Rafter to the Crown Fitting making

sure it is attached to the correct location on

the fitting (hip rafter location angle is less than

intermediate rafter location angle). Hand the

end of the rafter with the attached fitting to

the installer on the ladder and then attach the

opposite end to the 6-Way Mid Leg/Rafter

Fitting on the ground. The ladder can help

support the rafter at the top. A tent jack may

also be used to elevate and hold the rafters in

place while assembling from the ladder.

Now proceed to the first 21'8" Double Truss

Rafter location down the side (20' from the

corner) where another 6-Way Mid-Leg/Rafter

Fitting is located and hand the end of the

rafter to the installer on the ladder. After the

installer attaches the top end of the rafter to

the Crown Fitting connect the bottom of the

rafter to the 6-Way Mid-Leg/Rafter Fitting. If

you are using the universal cross brace fitting

be sure to slide the fitting into position before

attaching the rafter to the 6-Way Mid-Leg/

Rafter Fitting. Repeat this step on the opposite

side.

ASSEMBLY INSTRUCTIONS

10' Step Ladder