Anchor Navi-Trac Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Намет Anchor Navi-Trac. Anchor Navi-Trac 18 сторінок. Tent jack
Також для Anchor Navi-Trac: Посібник користувача (16 сторінок), Інструкція з монтажу (3 сторінок)

Друкувати сторінку

LAYOUT END MODULE COMPONENTS

HOOK THE END RAFTER TOP FITTING ONTO THE

PEAK/RIDGE WELDMENT. THEN SLIDE THE END

RAFTER ONTO THE BOTTOM OF THE END FITTING

AND BOLT.

UPRIGHT BRACES

END

HIP LOWER SPLICES

FITTINGS

AT TOP &

BOTTOM

NOTE: ONLY FIXED-BASE UPRIGHTS ARE TO BE USED IN END MODULES.

HINGED BASE UPRIGHTS ARE FOR MIDDLE BEAMS ONLY AND COULD-

CAUSE COLLAPSE DURING INSTALLATION IF USED IN AN END MODULE.

CONSTRUCT FIRST BEAM

FOR EASIEST ASSEMBLY, MAKE

CONNECTIONS IN ORDER SHOWN

AS BEAM IS PIVOTED TO VERTICAL,

THE EAVE BARS ACT AS COUNTER-

WEIGHTS TO MAKE THE LIFTING

EASIER.

BRACE, RIDGE

JOIN UPPER AND LOWER

RAFTER SECTIONS & BOLT

HIP UPPER SPLICES

RAFTERS, INTERMEDIATE

NOTE: ON END MODULES, EAVE FITTINGS FOR BOTH

EAVES AND RAFTERS ARE RIGID SLIP JOINTS.

CROSS-CABLE

OPTION: IF YOU ARE ASSEMBLING A SQUARE UNIT, THE TRAILING END

INTERMEDIATE RAFTER CAN BE ATTACHED TO THE PEAK NOW TO AVOID

LATER CONNECTING IT FROM A LADDER.

INSTALL RIDGE BRACE WHILE

BEAM IS FLAT ON THE GROUND

INSTALL CROSS-CABLE AND ADJUST TURNBUCKLE UNTIL

SPAN = 50' OUTSIDE-TO-OUTSIDE (APPROX. HALF OPEN).

HEAVY DUTY NAVI-

TRAC FRAME LIFTS

FIXED-BASE

UPRIGHTS

7-T

7-B