Anchor Liberty Xtreme MPA-500 Посібник користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник користувача для Стереосистема Anchor Liberty Xtreme MPA-500. Anchor Liberty Xtreme MPA-500 9 сторінок. Ac-powered sound system
Друкувати сторінку100-82-0/A, X50 2/6/01 9:58 AM Page 15
Operation
Liberty Xtreme 5000 control panel
Speech Project Switch
Bass and Treble
Controls
Speech Project
off
Line Input
(1/4" phone jack)
bass
Line In
Mic Input
cd
tape
(XLR jack)
Mic In
Phantom Power
Switch
phantom power
off
on
Balanced
Balanced Input
Input
xtreme
(XLR jack)
mixer
microphone
input level
line
mic
Input Level Switch
Anchor
CD
Input
Anchor CD Input
(4-pin XLR jack)
on
Power Indicator
PWR
off
Power Switch
Operating the sound system
1. Set all input level controls to minimum, and set bass
and treble to 12:00 position before turning power on.
2. Plug a microphone into a balanced mic input XLR
jack, or plug an audio source into a line input.
3. Turn power ON (red LED above switch will light).
4. Adjust level control adjacent to the input jack used to
the desired volume level.
5. Adjust the bass and treble controls (and speech
project switch, if necessary) for desired sound.
8
Input Level Controls
on
treble
Line Output
(XLR jack)
Balanced
Line Out
12 VDC Out
(300 ma MAX)
DC Output
LIBERTY
Fuse
MPA-5000
AC Power Cord
Receptacle
AC Accessory
Outlet
Fuse
Accessory
Outlet
Operation
Line Input
The unbalanced line input is used for playback of a tape or
Line In
cd
CD player, musical instrument, VCR or similar line-level
tape
source. It may be combined with the other inputs for a
composite output.
Note: All audio connections must be made with shielded cable
to avoid hum, buzzing or radio interference.
Mic Input
The balanced, low impedance XLR microphone input is for
Mic In
use with a balanced microphone to help prevent hum or
interference when using long cables. It has phantom power
for use with condenser-type microphones.
Balanced Input
phantom power
off
on
Liberty Xtreme is equipped with a balanced XLR input jack
Balanced
that can be set to allow microphone or line level sources, with
Input
xtreme
or without phantom power (15 volts DC).
mixer
microphone
A balanced microphone (Lo-Z) is preferred for use with long
cables to minimize hum and interference. Phantom power is
input level
line
mic
required when using mics with a condenser element; in all
other cases the phantom power switch should be set to OFF.
Anchor CD Input
Anchor
The Anchor CD input provides an audio and power
CD
Input
connection for the CD-1 CD player accessory.
Line Output
The line output provides a balanced, composite signal of
Balanced
the inputs being used. Use the line output to record your
Line Out
presentation, or to "daisy chain" another powered sound
system to the Liberty Xtreme for greater crowd coverage.
Accessory Outlet
Use the Xtreme 5000's accessory outlet to supply AC power
to an additional sound system or accessory. Anchor's
PWRADPTR or PWRCORD cables allow easy connection
when running extension cables.
Accessory
Outlet
9