Athena RMB/2 Короткий довідник

Переглянути онлайн або завантажити pdf Короткий довідник для Регулятор температури Athena RMB/2. Athena RMB/2 2 сторінки. Non-modular hot runner temperature controllers

Друкувати сторінку

OPERATING YOUR CONTROLLER

Assuming that all zone power and thermocouple are

correctly in place, turn on the controller using the power

switch on the back. The controller will complete its

startup sequence, and the process value and setpoint for

every zone (the standard operating display) are shown.

All zones will be Idle (all outputs oﬀ ).

If the controller has already been wired to the sensors

and heaters, do NOT push the run/idle

until after you have conﬁ gured the zones and entered

customsetpoints.

When zones are taken out of Idle, their outputs may go

on (check default parameter values).

Take unneeded zones out of service by setting them

to Oﬄ ine.

a) Select a zone by pressing the zoneselection button

until only that zone's PROC and SETP are displayed.

(Zone numbers are shown next to the row of status LEDs

for eachzone.)

b) Access the mode-selection function by pressing the

Access the mode-selection function by pressing the

mode/ enter button

c) Step through the possible modes by pressing

the mode/enter

button repeatedly until "Oﬄ ine" is

displayed.

d) Exit the mode-selection function by pressing the

Exit the mode-selection function by pressing the

menu- access/exit button

. A conﬁ rmation will be

displayed brieﬂ y and then the PROC and SETP for the

zone will be displayed as"OFF."

The green F (for Fahrenheit) or C (for Celsius)

LED is lit; indicating the scale being used. If you want to

change the temperature scale:

a) With any zone selected, press and hold the menu-

With any zone selected, press and hold the menu-

access/ exit button

until the name of a conﬁ guration

menu is displayed.

b) Step through the menus by pressing

repeatedly until the Display Conﬁ g menu name is

displayed.

c) To access the Display Units parameter, press

The scale will alternate with the parameter name on the

lower line of the display. An asterisk is displayed instead

of a zone number to indicate that the parameter applies

to allzones.

d) Press

to change the temperature

scale

e) Exit the menu system by pressing and holding

for several seconds and the PROC and SETP for all

zones (except any oﬄ ine zones) will be displayed in the

new selected scale. Any temperature values previously

entered will be converted automatically.

button

A row of LEDs for each zone indicates statuses for the zone and its output. These status icons are:

lit green when the zone's output is on

output:

boost:

lit green when the zone is in Boost mode

closed loop:

etc.

open loop:

standby:

alarm:

flashes red when the zone is in alarm

Buttons provide access to all controller functions. The purposes of the buttons are shown below.

Zone selection button -

the zone selection button is redundant and

removed.

Silence alarm button - silence time is con-

ﬁ gurable

Apply Boost to all zones selection button

Idle mode selection button - press for at

least two seconds to put all zones in idle

mode

lit green when the zone is in a closed loop mode, such as Normal, Closed Loop Boost, Normal Soft Start,

lit green when the zone is in an open loop mode, such as Manual or Open Loop Boost

lit green when the zone is in Standby mode or Hardware Standby mode

on the RMB/1

NOTE

Increase setpoint and upward scroll

through parameter values button

Decrease setpoint and downward scroll

through parameter values button

Mode and Menu item selection button

Mode display. Press longer to enter Menu

selection.