Formax FD 8502AF Посібник з технічного обслуговування - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з технічного обслуговування для Знищувач паперу Formax FD 8502AF. Formax FD 8502AF 19 сторінок. Autofeed shredder
Також для Formax FD 8502AF: Посібник оператора (2 сторінок)
Друкувати сторінку
Operation
1. Flip the power switch "ON" located on the right side of the shredder.
2. Auto Start/Auto Stop
When the START button is pushed, the signal lamp "AUTO" will light. Insert paper to shred. The shredder will start and
stop automatically when using this function.
3. Manual Operation
If paper is too small for the shredder's sensors to detect, shred it manually. Push the START button once more and the
"MANUAL" lamp will light. Insert paper to be shredded. Three minutes after shredding, the cutter automatically stops
rotating.
4. Reverse Operation
Push the REV button and the signal lamp "REV" will light and cutters will operate in reverse. If too much paper is inserted
at one time in standard modes, the shredder will automatically operate in reverse. If this occurs, remove the inserted
paper and shred in smaller amounts. NOTE: The maximum amount of paper to be shredded differs according to paper
quality, humidity and voltage. If the shredder is to be used continuously, do not insert more than half of the maximum
capacity.
5. Full Sensor
If the waste bin is full, the "FULL" lamp will light and the cutter will stop automatically. Open the door, empty the waste bin
of paper scraps, replace the waste bin, close door, and continue to shred.
AutoFeed Operation
1.
To use the AutoFeed Hopper, press "Start" to enter Auto Mode.
2.
Lift open AutoFeed Hopper Lid.
3.
Press down AutoFeed Lever and load up to 175 sheets of paper to be
shredded. Release lever.
NOTE: Load 8.5" x 11" paper landscape and 8.5" x 14" and 11" x 17"
paper portrait.
NOTE: Feeder does not accept staples or paper clips.
4.
Paper will automatically feed and be shredded. Cutting blades will stop
after shredding is complete.
5.
Close lid when AutoFeed Hopper is not in use.
AutoFeed
Lever
2
AutoFeed
Hopper Lid