Formax AutoSeal FD 1506 Plus Посібник оператора - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник оператора для Економія їжі Formax AutoSeal FD 1506 Plus. Formax AutoSeal FD 1506 Plus 18 сторінок.

TROUBLESHOOTING

C. Paper is not folding square (Skewing):

Figure 10

D. Machine plugged in, no power

1. Turn machine ON.

2. Make sure top cover is installed properly.

3. Press the circuit breaker (Figure 9).

4. Check wall outlet.

5. Remove operator cover check the fuse located on control board next to transformer.

6. Check all electrical connections.

E. Double feeding / Mis-feeding

1. Clean feed wheel, using soap and water.

a. Check center in-feed roller and singulator pad for wear. Replace pad if it is cupped.

b. Check to see if center in-feed roller is centered on the gate tip.

2. Run a stack of plain paper. This is done to check on proper feeding. If double-feeding does

not occur on the paper:

a. Check to be sure pressure seal forms are not sticking together. Jogging or hand

separating may be necessary to determine this.

b. Hand separate about 50 forms, align and test-run the forms. If no double feeding

occurs, proper forms handling is necessary.

3. If double-feeding continues to occur, the next step is to check the gate tip pressure.

1. If paper pulls left or right adjust the skew. Turn

the skew adjuster, located under the infeed tray,

(Fig. 10) left or right until the paper is feeding

correctly.